|13-09-2008||It's already junk unless he charges the battery out of the phone so you can't really make it any worse.|
|13-09-2008||Electronics EFD7015||Hi everybody
I have a LCD TV with dvd player inside and the customer have use wrong dc adepter and now it whill not start upp no power supply. I have check and found somthing wrong with the MP1430 DN i dont have 12 volt out from this cicurit only 1volt|
|13-09-2008||Samsung HL-S6187W DLP TV (2006 model year) Service Manual||Hi, I'm looking for this service manual since I need to do a full video system calibration. The service menu has extra functions for calibrators that the user menu does not offer (such as permanent DNR and DNIe disabling as well as RGB High/Low controls)|
|13-09-2008||mitsubishi vs-45609||On D952 I got 10.6vdc ,D970 I got 4.5vdc but d972,d521,d520 and d522 I did not get anything... The IC chip was purchased from suburban electronics|
|14-09-2008||Well I finally was able to do the repair on this set. I ordered the wrong caps at first. I ordered the diode type, reordered the correct ones. Replaced the caps Minnie recommended and also cleaned up the area on the board. It was hard to see the leaking c|
|14-09-2008||plz i need nissan micra 03 radio code||nissan micra
|14-09-2008||Matsui LM20N2 LCD TV - Service Manual or Schematics||Good Day All.
I have a Matsui LM20N2 LCD TV, a few months ago the when you pressed the power button to come out of standby the power LED would go green for a split secound and then go red again.
I then took the unit apart and found some fried part|
|14-09-2008||Monitor KDS Model KD 2100K||Hi, i need Eeprom Bin this Monitor Kds Kd2100k , or:
- Princeton EO2010
- Miro D21117F
- Kds Vs21
Please post in email@example.com , Thanks for any help.|
|14-09-2008||Monitor KDS Model KD 1200K||Correct model is
Monitor KDS KD1200K Fcc Id evokd2100 or:
All moitors fcc id = EVOKD 2100, thanks all, sorry for wrong. I need eeprom bin, post to firstname.lastname@example.org ,|
|14-09-2008||You'll stand a better chance of getting a favorable reply if you bothered to post in the correct forum.|
Please can someone help, i'm looking for a service manual for my Home Cinema System.
|14-09-2008||Samsung HT-THQ25 problem||Hi,
I have the above Home Cinema system and it worked fine up until this weekend, now when I switch it on it loads up the disc thats in the tray and then the sound goes and the picture becomes corrupt with all coloured lines horizontally, it just stays|
|14-09-2008||Justmanuals: Thank you for your reply, as this was my 1st post I was unsure if I should of place this in the "Service manuals & datasheets" or here in the "Equipment Repairs".
Yes I am asking for the Service Manual or Schemati|
|14-09-2008||Doubt if you'd be able to find a specific schematic due to the nature of what is being marketed for some time (disposables). Time after time, it is simply not worth the hassel/cost involved hunting down for something that was not meant to be repaired even|
|14-09-2008||vtech: Thanks for your reply, I have just had a much closer look at one of the old parts, when wet you can just about make out some markings.
I am not 100% sure if this is right, the marking are quite small.
|14-09-2008||can you check against the others & possibly post a picture?|
|14-09-2008||The print is very small, but it does look to be the same on each.
Here a picture of the power board.
As they are so small, I can't get my digit|
|14-09-2008||And here is a picture of the lables on the PCB.
And here is the print on the PCB.
|14-09-2008||I actually meant a picture of the face of transistor where you can kinda see the numbers on
BUT, In looking at the board pix, not quite sure if they are infact FET's? ---blurry?, are the 3 letters stamped on the board (inside red circle) ECB OR GSD?|
|14-09-2008||vtech: I know that you wanted a picture of the face transistor, but I just can't get a clear picture of it so did not bother uploading it.
The PCB marking for the transistors are ECB.
|14-09-2008||ok, the designation ECB is definitely NOT for FET. let me do some checking & will post back|
|14-09-2008||tevion md7115/schneider 17 TV||I try to repair tevion md7115 which has a variant of shneider 17 chassis.
I replace the transistor Q307 (horizontal output transistor), because it was bad. After that the TV has a clear picture on screen but for very short time. The transistor has overhe|
|14-09-2008||Samsung Synchmaster 204b, flashing blue light, sound||Hello.
I came home one day to see my monitor's power light blinking blue. After researching the problem on sites, I tried to see if changing the frequency would fix it. It did not. With the power on, you can see the blue power light flash on/off every|
|15-09-2008||want to build a power supply||hey guys [color=red:52718d60be]i want to build a power supply but not just any power supply i want to build one that can out put 50 Volts and 30 Amps...it has to have variable control for both voltage and amperage as well as 2 different analog meters disp|
|15-09-2008||wanted avenger test chip||i want an avenger test chip latest model preferred to decode analog cable....preferably new with everything...wire harness and instructions on how to install....
if used it got to be in perfect working condition no cracks..no adjustments...no damages n|
|15-09-2008||Akai model # PT5492S||I have an Akai PT5492S 2002 that wont turn on at first. It makes a Buzzing/sizzleing sound. Also the Timer light on the front panel stays lit. The only way to try and get it to turn on is to unplug and plug it in multiple times sometimes this works and th|
|15-09-2008||[quote:1037c67bb3="Mad Professor"]vtech: I know that you wanted a picture of the face transistor, but I just can't get a clear picture of it so did not bother uploading it.
The PCB marking for the transistors are ECB.