Date | Header | Text |
23-11-2012 | | This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from:
http://www.justmanuals.com
[email protected]
Your English is better than some people who were born and raised in the US. |
26-11-2012 | AVR7000 HK surround problems | Hello all,
I am loate to bring back a zombie thread, but well my amp turned into a zombie so I figured it was OK.
OK so the avr7000 works perfect in stereo mode but has issues in all the other modes. If you put it in any of the surround modes, it cuts |
26-11-2012 | | Certainly can cause all sorts of problems. Your listed caps are in 3.3V AND 5V lines & are all 1000mf6.3v electrolytics.---& there are more of them. If I were you I'd replace them all with at least a 10V cap.
Go to elektrotanya.com & dload th |
26-11-2012 | This solution worked! | My DRA-685 was working until I was using it with headphones for a couple of hours with the speakers turned off. I turned it off the stereo for the night and tried to start it the next day, but as soon as it turned on it blasted some static noise, then tur |
26-11-2012 | Got the manual | I have the manual and have been looking @ it till I turned blue ...
OK all them caps 10v 1000mf ? Find and swap all of the 6.3/1000 ... or all the 6.3's regardless of their mf ... and on other boards ?
Thanks so much.
Srinath. |
26-11-2012 | | What I meant was to change the working voltage> 6.3v rating to 10v rating.
No need to change the capacitance value.
In the world of consumer electronics, 6.3volt caps are problematic.
Their use is strictly a cost issue. When you have a 5 volt line a |
26-11-2012 | | Firmware update? Model? Dr Seuss? |
26-11-2012 | All 6.3 to 10 | Yea I understand, but there is a few more 6.3v 1000mf caps on a few other boards too. Searching it now ... Actually there is only 2 more on the whole amp. I am going to hunt down and replace those as well. Hopefully they are not hard to find.
Now while |
26-11-2012 | TX sr 805 needing a firmware update | I'll look @ the youtube video, but I have a TX SR 805 onkyo that needs a firmware update. I hope its nothing else.
Thanks.
Srinath. |
26-11-2012 | Great video, Thanks. | I've heard of the 805 also needing a smd cap replacement. I will get the firmware updated and the smd's on it swapped too.
Thanks.
Srinath. |