Date | Header | Text |
29-09-2009 | | It means if you don't understand his reply, you need to call a technician.
My the way, my wife has this monitor. Today we plugged it in for the first time since we moved across the country and we got nothing. Everything looked ok. I changed the power c |
29-09-2009 | | Location numbers (number on the part). :roll: |
29-09-2009 | | Take the value of the resistor - add 10% and subtract 10%. If the value you read falls within this range - resistor is good. Example: 100 ohm is good if reads anywhere between 90 and 110 ohms. :wink:
I only used 10% as an example, yours may be 5%? |
29-09-2009 | | A defective motor itself could also cause. :wink: |
29-09-2009 | hidden cod lg -37LH70YR-TA | hello every on
please send to me hidden cod tv lg model 37lh70yr-ta .
thanks in advance |
29-09-2009 | SONY Radio Cassette Corder Model CFS 200 | Dear All,
Can anyone help me in sending Schematic/Circuit Diagram of Sony Radio Cassette Corder Model CFS 200 as the radio section has gone faulty. E-mail: [email protected]
Thanks in advance...
regards,
elec_sham
===== |
29-09-2009 | Sony KLV-S40A10E died | Hi,
All of a sudden my 40"LCD died. When pushing the standby button nothing happens. I checked the fuse on the power supply board but the fuse is OK. From the schematics i suspect a transistor that drives the relay coils (Q6400)
I didn't have the |
29-09-2009 | | yeah i have the same thing... if i hold the power down it dose tend to come on (most times) few times it has stayed off for hours on end no matter what i do.
my unit was fine for the last few days in the last hour or 2 tho its been on and off again :( |
29-09-2009 | | Well it was a success! I firstly replaced the Q533 and then there was a bad solder on the T511 which i fixed, also i resoldered the line drive tx T531. Put everything back together and the television works smoothly now
It was my first television repair |
29-09-2009 | | You can get the SONY CFS-200 service manual and schematic at www.schematics.me |
29-09-2009 | | check standby 5v supply which should be present all the time the set is connected to the mains, d6903 is notorious for going s/c and causing psu problems, check and replace ic6300, ph6300 and ic6301, the relays will not operate without the sby 5v being pr |