Date | Header | Text |
09-09-2007 | Does anyone the service manual of the sanyo TV | Hello.
Does anyone the service manual of the sanyo TV, model CE29FFV3-F?
I´ve been looking for it, but i don´t find any information.
Thanks |
09-09-2007 | Well, it's working again | Well, I am still none the wiser from studying the Sony Service Manual how the 8v supply is supposed to be derived on the cost-reduced version of this chassis, but this particular set is now working again. Installing an 8v regulator in the space where IC6 |
09-09-2007 | Hitachi Projection TV Protection Screen | Does anyone know how to get the Clear Protection Screen off the Hitachi Projection TV?
It is the Clear protection Screen that is on the front of the TV?
Thanks,
B |
09-09-2007 | JVC HV-28D40BK - Service info needed | Hi 1&All,
Am desperately in need of any Service info for a JVC HV-28D40BK
28" DynaPix Widescreen Flat CRT TV
Not sure what chassis details are. How would I find that out?
Thanks in advance for any useful info supplied to me.
M |
09-09-2007 | | What's the model? |
09-09-2007 | | http://www.vizio.com/support/
The toll-free # is 1-888-849-4623. They are located in California.
Suspect the inverter/inverters are bad or the source voltage to the inverters is bad. |
09-09-2007 | | More likely, it is a flashover in the CRT from the EHT (anode) supply to the focus or screen grid, and then the flashover current takes the way through the spark gaps to ground.
Before blaming the CRT, check that the spark gaps are clean, disassemble a |
09-09-2007 | | Maybe, it could be a problem in the switching between the two vertical channels. Try switching off the other channel (or change between "alt" and "chop" mode) to see if the ghost image disappears.
Also, it is important to have good |
09-09-2007 | bush dvd147tv - intermittently sticks on stand-by | Occasionally, a dvd147tv will remain on stand-by no matter what you do with the remote or the set controls. Then it will suddenly start working OK.
This can happen from stand-by or when the set is powered up. When it is in "fault mode" the le |
09-09-2007 | TV SHARP14' FORGET PASSWORD | i have tv sharp 14'.i forget password .now i canot tuning tv for new channells.how can reset the password. |
09-09-2007 | Samsung 760V TFT LCD monitor goes black on turn-on | Common problem with these apparently, you have to turn it off and on over and over to get the screen to properly light up which it eventually does, otherwise turns black in a few seconds. If it is the inverter, which inverter board do I get, and is it po |
09-09-2007 | magnavox MS3252s431 no pic or sound | Couple of months ago my tv started giving problems. don't remember exact symtoms. Took it to a repair shop in my area but guy said he could not repair as part cannot be found. It has been sitting down for a while and I decided to take it apart and see wha |
09-09-2007 | | definitely optical block.hitachi well known for failures on lcd rear projo. |
09-09-2007 | | good idea to hook up another tv and see if problem still exists,if so not tv.or hook up vcr on channel 3 or 4 and play tape,if tape clear, cable problem.if not tv tuner problem. |
09-09-2007 | Tv RCA 32V434/ Chasis ATC010A Do not turn On. | Have a RCA color Tv 32V434, Chasis ATC010A, after it's plug in,you hear a click, then it stop, the power button then start to blink few times, then stay lit, with a blinking red power ligh.
Thank you on any help. |
10-09-2007 | | Typical RCA replace the fly back and check the horizontal out put transistor. |
10-09-2007 | | Good old NAP. Replace C2455 47@25V. Other most common is the HOT shorts in this one. |
10-09-2007 | | Got a model #? |
10-09-2007 | | I Will check that first.
Thanks minnie. |
10-09-2007 | AVR-2105 | Yo tengo un problema similar al tuyo con un AVR-2105. Se enciende de forma intermitente en rojo el botón standby que está al lado del on-off.
Tiene la resistencia R115FL quemada. Lo he llevado a reparar a un servicio técnico y me han camb |
10-09-2007 | L01.2A Chassis Shutdown | If someone has experienced this fault before, kindly help. Thanks in advanced.
Philips 21PT3324
TV set comes on then picture and sound shutdown after few seconds.
H.O.T. voltages are C= 35Vdc; E=18Vdc; Vdc= 18
I have tried to replace the controlle |
10-09-2007 | feerguson tv going in and out of standby flashing 2:7 | hi did you manage to find out how to sort the problem i have a ferguson also with the sane issue, do you also know how to get into service mode |