Date | Header | Text |
30-03-2009 | Gateway Laptop Model MA7 --- MT6840 | My laptop won't turn on. If the battery is completely dead, even if the laptop is plugged in via the power cord, will the unit not turn on? I wouldn't think the battery would matter. All I get is a flashing red light instead of the blue light when I try |
30-03-2009 | | Rejuving the CRT may give you set a few more years, if done correctly. |
30-03-2009 | How do I find out | How do I find out if my TV has a switch to digital?
I have been reading about the analog to digital switch and it sounds like some TV's made in the last year or two may have a switch to digital, so that you don't need the converter box.
My TV is a F |
30-03-2009 | | Have you tried reading the owner's manual?
What about the manufacturer's website?
This switch to digital is only in the USA. I don't even think Orion is even sold in the US. Although I may be wrong on that.
HtH
[email protected] |
30-03-2009 | | While Orion brand is sold in the US, there is no such a thing as a "digital switch"inside the TV.
Usually, there should be some indication such as "Digital Tuner" or "ATSC Tuner" listed in the owners manual. |
30-03-2009 | hitachi 50ux15k | hi all, i have a hitachi 50ux15k rear projection tv with a convergence issue. upon pulling the board out i found that four of the resistors next to the stk chips are burnt up. however, i have no idea what they're tolerances are as the colored lines are un |
30-03-2009 | | Okay - thank you. I will check both of those. |
30-03-2009 | dtv not working | Hi, i have a SHARP LC32P70E but it hangs when on dtv and the remote dont respond properly, the only way to get it off dtv is to put a scart in when i do this it functions perfectly.
does anyone have any idea why this happens.
thanks |
30-03-2009 | Re: Xerox 5028 document feeder | [quote:8cd347a368="aluwishous"]My automatic feeder both single sheet feeder and multiple feeder sections will not work. The multiple feeder light goes on but nothing happens. This problem first occurred after the machine was worked on by a non-xerox tech |
30-03-2009 | Blown resistor on plasma PSU | I have the same problem - 0.1 & 0.47 ohm resistors blown apart - what are Q125, Q127, & Q128 and how do you teast them? - Did anybody manage to get their board working again? |
30-03-2009 | 5028 Feeder problems | Slacken off the 2 thum screws holding the Doc feeder to the copier, force the Doc feeder to the left, try to feed paper,if no good then to the right and feed paper. if it works it is the Doc feeder home switch and magnet out of alignment. switch at the re |
30-03-2009 | | When you go to select signal type (antenna/cable, etc) and auto program stations it should ask you "analog" / "digital" . |
30-03-2009 | NTC monitor ultraview | i have a problem with my 17 inches monitor model km-712,no pic with continuos led blinking in front panel. I replaced the transistor C5552 and pic went back with yellowish in color for awhile until slowly went down. check the same transistor and found out |
31-03-2009 | Videorecorder: Philips VR 810 Hifi Stereo: remote control?? | Hi you all,
I bought a second-hand videorecorder ("Philips VR 810 Hifi Stereo") yesterday.
I found the manual on the internet.
However, the remote control that is on the drawing of the manual is TOTALLY DIFFERENT from the remote contro |
31-03-2009 | ASUS P5B-premium | I have a problem with ASUS P5BPREMIUM motherboard ,few days ago my graphic card had burnt out,and now after buying second graphic card computer doesnt start(checked with other computer it did fine),fans are spinning,light on the motherboard is ON,Hard dis |
31-03-2009 | | Does this mean it is the wrong remote controller?
Yes, I don't even see "operation" (Play/FF/REW) buttons.
Looks like a television remote based on labeled buttons. |
31-03-2009 | | Hi, thank you for you answer.
Are you very very sure this can't be another universal remote control?
Is it ALWAYS necessary to have FF Play Menu etc labels on the remote contol?
(the seller told me she was very sure it was the right remote contr |
31-03-2009 | | you paid with a credit card right? Send it back.
[email protected] |
31-03-2009 | | No, I paid cash: I found it via an ad online, and yesterday, I went to get the devices at the daughters of the sellers home....
I already sent messages today to aks for more information, but she is working....
I want to give it back, but she will n |
31-03-2009 | | An add online......Well, since you paid cash its highly unlikely you're going to get your money back, see if you can leave feedback for the seller.
Where was the add? |