|10-04-2008||SLEH790||HI I RECENTLY WENT TO TURN ON MY PANASONIC SLEH790 HOWEVER, IT JUST MADE A BUZZING SOUND AND TURNED ITSELF OFF, AND KEEPS DOING SO EVERYTIME I TRY TO TURN IT ON..
THE SYSTEM IS IN A ROOM WHERE I KNOW NO LIQUIDS COULD OF BEEN SPILLED ON IT AND IS POSITION|
|10-04-2008||FORGOT TO POST MY EMAIL ADDRESS FOR REPLIES !!||firstname.lastname@example.org|
|10-04-2008||changer||can't tell you what model, but nissan usually uses clarion ..|
|10-04-2008||I suppose that it is a single phase transformer ? Then, one possible way that it has delivered a too high voltage is that the primary is intended for connection between one phase and the neutral conductor, but then by mistake was connected between two pha|
|10-04-2008||Toshiba Portege R200 LCD Mod||got a Toshiba Portege R200 with a broken LCD.
I have a M200 screen that I want to use since it has a higher resolution. The lcd fits in the laptop but the problem is that the M200 LCD-panel (LTD121KM1K) have a 30 pin connector and the R200 LCD-panel (LTM|
|10-04-2008||A common fault on older Samsung VCRs from the late eighties was that the connector at the erase head went open circuit due to incompatible platings on the pins and sockets causing an invisible but insulating oxide layer. This caused very weak sound record|
|10-04-2008||Are those lines above or within the active picture area? It is very common that TVs and CRT monitors with automatic cut-off adjustment gives those three "sense lines", but they should normaly be above the visible area of the screen. If they howe|
|10-04-2008||Philips ktv 25PT910A (FL1.17 ch.)doens't com out of stanbby.||Hello I have philips ktv 25PT910A
It stays in stand by mode.
If I look that the SOPS is switching off the tv due to the PROT
PROT signal stay at 0.8 volts
If PROT signal stay low it could com from sevral sources.
But how can you measure on th|
|10-04-2008||I have looking at the + and - 11V. Those voltage levels are not there.|
|10-04-2008||01 Samsung not turning on with or without remote!||I have a 35" (2001) samsung and it just stopped turning on ..
It does not turn on with the remote either..
If anyone has a suggestion please throw it my way
|10-04-2008||hp 1490 monitor||need a service manual for the hp l1490 lcd monitor
|10-04-2008||anyone got this service manual aiwa NSX-K970||can anyone help me find this service manual
|11-04-2008||Onkyo AV receiver sound problem||Hi, I have an Onkyo HTS780 receiver and I am having a problem with my coaxial sound, I'm not getting any. I have the audio out from my tv hooked up to the coaxial port on the reciever and has been working fine for over a year but since last weekend I hav|
|11-04-2008||LG audio amp turning on and off, HELP?||ive got the LG Xtremo LM-M1040,
and over the last 6 months, whilst listening to music, it turns it self off, display light and all disappear, but if i disconnect it from the wall socket after 10 seconds when i plug it in again, it works,
it was fine in|