|08-11-2008||manual||Hi, did someone already find the manual for the Proscreen 4600.
Please send it to me by email
|08-11-2008||a really electronics dummy question||www.NONEEDTOADVERTISE.com
what does the X stand for when you guys talking about TX & RX ?
T = Transmit
R = receiver
X = ?|
|08-11-2008||Need help Viewsonic LCD TV VS10848-1P||Have problem with Viewsonic LCD TV model VS10848-1P. Set dead, suspect power supply? Power supply model = FSP276-3F01. No obvious fault found with this PS. Have 5 volts only when powering up separately from TV on bench. Not sure what other voltages s|
|09-11-2008||Hi Minnie thanks for the help But the line is not horizontal line it is vertical line ( from top screen to bottom ) the picture is on that thin line on the middle of screen. ? so can that be a failed vertical IC. & what r the pump up caps ? in which a|
|09-11-2008||So I replaced the convergnece ic's and resistors, the color in the top left is ok now but now when I try to adjust the digital array the left and right center crosshaiars are in too far. The red and blue will not move in far enough. the screen looks bowe|
|09-11-2008||Sanyo C25EP57NB (25DN2)||Hi
I am looking for a Service Manual for the Sanyo C25EP57NB (25DN2).
The picture on this TV first started to get really dull looking, but how when you put it on, it stays on for about 20 secounds and then goes onto standby and the standby light sta|
|09-11-2008||Need help on a Plasma Grundig planatron pw 110-520/9||Folks,
Issue is a very famous fault on this Plasma: Picture disappears and screen stays black, after rebooting the same game.
My knowledge so far:
My 180 and 60 V misses a short time after boot up.
This may take a short or a long time but not more tha|
|09-11-2008||...so can i go forth and replace the STK, or will the new one probably die too because of some other fault that caused this one to fail?
The new IC costs around 30$ in Croatia and since I'll be spending my pocket-money on it I don't want to lose 30 buck|