|12-08-2013||[quote:9deed84ba0="jts1957"]Dot gen and 170 Volt supply are external to set. You will NOT be performing ALL steps.[/quote:9deed84ba0]
Ok cool, since I wouldn't have access to such equipment.
[quote:9deed84ba0="jts1957"]Stay OUT of Service Menus!!![/qu|
|12-08-2013||I figured what the heck, it doesn't cost anything to try turning that adjustment the other way, and just in case, I made that small adjustment while it was turned on. And for the moment, it may have worked, as the tv is still turned on (for now).
|12-08-2013||Sencore tf46||I am interested in your sencore tf46 you can contact me at 808-216-7026 Chris .|
|12-08-2013||many thanks for the service manual now the fun begins :P|
|12-08-2013||Sharp 70" LC70LE633U with flashing power light||All my 70" Sharp will do is flash the power light in the middle of the set.
I get a short flash and then a long flash and then it repeats.
Does anyone have the manual that'll tell me what the error code is saying?|
|13-08-2013||It's either the letter "A" or the letters "E'' & "T" depending on whether it's a dot-dash or a dot and then a dash. But seriously:
|13-08-2013||Looks like a dodgy company - with no address whatsoever...
Everyone should avoid sending money to companies like this.
Thank you though|
I don't understand what you mean by the letters "A", "E" & "T".
I found the manual as you pointed me and it shows the problem as "Lamp Error".|
|13-08-2013||Infocus In116 service manual||Looking for a service manual for this projector due to a failed power supply.|
|13-08-2013||Without seeing the black and smokey area, there is no telling where this came from. Are there any parts nearby that are deformed or
If you find domed caps, it's worth changing them out. Look around because there are usually more than one that goes. S|
|13-08-2013||This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from http://www.justmanuals.com
|13-08-2013||Another thought came to mind, sometimes a solder connection can get cracked and the connection arcs and burns. Depending if it burns just the solder or if it damages the traces, you can sometimes just clean it up and resolder that connection and it'll wo|
|14-08-2013||Check all electrolytics.|
|14-08-2013||[quote:660254011b="jts1957"]Check all electrolytics.[/quote:660254011b]I did replaced all with Panasonic brand.|
|14-08-2013||Just a heads up||Hi,
I'm just dropping a note to confirm that since that little intervention with the G2 adjustment, the tv has stayed on and the issue (so far) has not returned.
The one thing to note is that turning it counterclockwise didn't do anything, but then |
|14-08-2013||According to the service manual and your link, it translates to "N" in morse code.|