Date | Header | Text |
15-03-2008 | Dum my attempting to clean vid hds! | Lissen you utter fool- when you clean the heads with alky you must wait till alky dries off B4 you insert cassette- also you have probably damaged at least i vid head by rubbing the wrong way or else using excess pressure- kind regards, Kent. |
15-03-2008 | | I would check the degauss positor, they're infamous for falling to bits, take it out and give it a shake, a faulty one normally has plenty of rattle, also check the chopper IC. Hope that helps. |
15-03-2008 | | Also, don't forget to discharge the mains reservoir capacitor, a lot of philips sets hold a charge with these type of faults. :!: |
15-03-2008 | | Yeah. Thanks to the owner! :) |
15-03-2008 | | Usually, when it says there's a CRC error, it means that you didn't get the full archive. :wink: |
15-03-2008 | Avatars | Why we can not use avatars? :( |
15-03-2008 | Samsung PCL5415R X/XAC | Where do I find the heat sink to check the fuses? |
15-03-2008 | | There attached to the two STK392-040 IC's. |
15-03-2008 | | Is this an LCD model? |
15-03-2008 | | This Parts & Service manual can now be purchased for $9.99 and downloaded immediately after payment from:
http://www.justmanuals.com/samsung-projection-receiver-pcl545rx-pcl5415rx-pcl5415r3c-pcl6215r3c-hcl552wx-hcl5515wx-hcl652wx-hcl6515wx-chassis-p5 |
15-03-2008 | | Verify your vcc. Your + and - voltages to the ic's. If it's ok you have a bad dcu. Have you pushed the white button on the front of the set and tried adjusting it in the service mode?
DCU HC2153 DP14G- DIGITAL CONVERGENCE UNIT |
15-03-2008 | | [quote:7d8e4b0dd7="Justmanuals"]Well DUH! Ever heard of Google?[/quote:7d8e4b0dd7]
What's a google? |
15-03-2008 | | Hi
no its a crt9625 |
15-03-2008 | | Hi
no its a crt
Not crt9625 :oops: the keyboard went nuts |