|14-10-2011||Maybe close enough?
|14-10-2011||BOSS / ROLAND BR-8 Multitrack Recorder||Hi All
I have two Boss/Roland BR-8 recorders that have the following symptoms:
Erratic behavior at power on. Sometimes the units will work for a few minutes, then lock up. Other times they will power up but with a blank screen. On occasion they will|
|14-10-2011||blaupunkt travel pilot e1 maps||Hello, how i can found spain's map of blaupunkt travel pilot e1
it's no dx i think
thanks in advance.|
|15-10-2011||about hp2320||i have installed a new toner cartridge for my printer , but it (printer) does n't recognize it.
what can you sugget me please.|
|15-10-2011||TEAC GA-780 SERVICE MANUAL||Hi Guys,
I'm looking for a service manual or schematic for a Teac GA-780 receiver. I need the manual or schematic to identify the componets on the circuit board.
Thank you in advance for your assistance.
|15-10-2011||Sansui A-1110 No click when powering up||Hello All,
I am new to this forumn, and was trying to get some direction on what to check for on this Sansui amp I am trying to troubleshoot.I opened up the amp,and saw that the power on relay had a burnt spot on it as I looked at it.
I am not sure wh|
|16-10-2011||Re: Sony KDS60A2000||[quote:27b465bc65="Rlreynolds"]ok thanks, I will order one and try it, and see what happens. Thanks[/quote:27b465bc65]
Rlreynolds - I have the same tv & same issue. Did the new lamp resolve the issue?|
|16-10-2011||You may need this:
|16-10-2011||Which connector pins get jumped?||[quote:cc63b53e55][/quote:cc63b53e55]The pip board is a plug in board to the main chassis. Look for a brown wire going to it. You can jump it by removing the board and jumping pins 5 and 11 with a either a 47uf/50v cap and pins 7 and 9 with a .1uf/50v cap|