|Hi, ive got the same screen and ive fixed the fuse but still no light from it. But it produces a high tone.
|Sony KV35S42 shuts off
|Unit had bad HOT and IC601. I replaced all the shorted/open parts with the rebuild kit and resoldered both boards. The unit played for 2 weeks and now shuts off after a 30 seconds to 2 minutes. Does anyone know if their is a suspect cap or something I
|e un model ciudat
|Re: Electronics General
|[quote:cf06fd5260="saurabh1985"]Which type table given u.can u tell me please.[/quote:cf06fd5260]
The table is the datasheet from NEC
|5028 doc feed problems
|Hi, sorry i have been away. Switch off, press hold 0, switch on.enter 5 then 3. the doc belt should run.press the red button on the console to stop.If the feeder runs it means the feeder is ok, if it does not you have electrical problems.if it runs enter
|I have this exact issue from this exact TV model.
I bought and replaced the DSP board, did not help.
Could be the T-Con board... will update this thread if that works.
|any idea how to take off front screen to clean mirrors on hitachi 61sdx01b projection tv :o :D
|Re:N3235W viewsonic, need help please
|minnie, should i risk it and order a Digital video board, what do you think?
JTS1957, with all respect, i've looked over the internet inside out, so i didn't miss that, but as you see there no body went had N3235w symptoms like mine. i really appreciate
|moving diagonal lines on monitor
|In general, what typically causes moving diagonal lines on a monitor? The space between the lines changes. Sometimes the lines are spaced far apart and then they get closer and closer and move faster and faster. And then they go back to being slow and wid
|Do you mean the high voltage lead? Still kinda confused?
|Number of possibilities;
Based on your description, sounds more like an interference. Could be internal (such as switch mode power supply radiation) or from an external source which can be rather difficult to find. I have seen something similar to your d
|I'm fairly certain it isn't external interference because it's not an intermittent problem and I've had the monitor in two different locations in the shop when I've tested it.
How would I find internal interference?
Could it have anything to do with a w
|Try turning down the SCREEN control on the newly changed flyback?
|Hmmm... the only controls on the flyback transformer are contrast and focus.