Date | Header | Text |
18-01-2008 | 60 inch philips projection t.v. | Hello i have a 60inch philips projection t.v i had this t.v for almost 10 years now,my ? is the pictures is not that sharp any more . Thats understandable because its getting old, but you can still see the picture
is there any way that i can be able |
18-01-2008 | caps and fuse | replaced bad caps and pico fuse on the backlight side of circuit. now is working great! |
18-01-2008 | | Convergence IC's in this case are dual amplifiers. On IC does red and half of green. The other IC does the other the half of green and blue. You have 6 resistors, one does red vertical and one does red horizontal, one does blue vertical and one does blue |
18-01-2008 | Sony KP-43HT20 | Turned TV on and only one of my color guns is coming on (Blue one). The red and green don't seem to have any power (not glowing). Anyone know what might be common to both the red and green tubes?
Thank you
Dan |
18-01-2008 | | The blue and green tubes have algae growing in them. They are filled with glyglocal alcohol. You pull the tubes out, take the lens's off, drain them, clean them out, and refill them and your picture will be good again.
RCA#212072 subs to number:MGC803 |
18-01-2008 | | Sony's have a blue video mute. What does it look like with a signal applied? |
18-01-2008 | Sanyo service mode DS25204 | I think that I entered service mode by pressing menu on both the set and remote. Now that I am in I have no idea what to do. Does anyone know how to change the vertical and horizontal sizes on this television? Any help is greatly appreciated. |
19-01-2008 | | Thanks.
I did open up the monitor to take a look when it first started happening. I have not used the monitor since then becuse it obviously had a problem (and I didn't feel like waiting forever for it to be operational all the time).
Don't think I |
19-01-2008 | | Thanks. I found a bad solder joint at jumper 010. Could that be what caused the TV to go out to begin with? Or was that a result of a component failing and putting to much current through the jumper? |
19-01-2008 | Sony XL2100U projection lamp | I'm looking for how to test the xl2100u lamp with an ohm meter. Any help?? |
19-01-2008 | Philips tvw ith 5 blinks | I have found a source that says 5 blinks means failure of the 3.3v or 8v rail. b/r Troo. |
19-01-2008 | | Thanks a lot guys. will check it up...
:-) |
19-01-2008 | Tryin to identify the model # of my philips tv | I am completely technologically illiterate. I recently bought a tv from a friend of mine, and I have no idea what it is. It's Philips brand, dimensions roughly: height 34 3/8", width 34 3/4", depth 11 1/8" at the top, 25" at the bottom |
19-01-2008 | IBM P260 Model 6552-63N Monitor Service Manual | It can be found in pdf format either at www.ibm.com or www.lenovo.com
First try a Google search against both url's, limiting your search to pdf files. Service documentation & support responsibility for legacy IBM product, including Sony Trinitron-bas |
19-01-2008 | IBM Model P260 6552-63N Monitor Service Manual | Since the 'EDIT' button, described in the FAQ's, is not to be found this page: Here is the correct url to use to commence your search.
http://www-307.ibm.com/pc/support/site.wss/homeLenovo.do?country=us
That will take you to the Lenovo Support & |
19-01-2008 | Re: Philips TV problems | I have a 21" PHILIPS colour TV purhased just 1&1/2 year ago. Just 2days ago, due to mishandling of Remote controller by my 6years old child. TV shows "MONO" on right corner of the screen & the audio is not coming from the TV.
T |
19-01-2008 | Schematics for APC Smart UPS 5000 | Hi!
Is there anyone that have or know where I can find a schematic for a APC Smart UPS 5000?
Best regards,
Johan Christensson
Sweden |
19-01-2008 | | Did you ever find a manual / schematic? I need them too!
Bryan |
19-01-2008 | Computer monitor schematics? | I have an older HP Pavilion desktop (Model 9600) with an HP monitor (Model D7480A) that I really like. HP also refers to this as an S70 monitor. The monitor just went bad, and with some time on my hands, I wanted to take a shot at fixing it. Anyone know w |
19-01-2008 | | Sorry you can not. |
19-01-2008 | | The bad jumpers will cause 850 or 851 to blow but with finding a bad resistor your convergence ic's failed. |
19-01-2008 | | Horizontal Driver Xformer deflection Kit 4835 3105 7673 |
19-01-2008 | | Sorry but I've been away for a couple of days. Check for any over heating on heatsinks and specially power resistors. If not check/replace c820 - 220uf/160V and c829 - 100uF/160V. If these also proove to be ok my bet will be C810 - 470uf/16V on the primar |
19-01-2008 | | On the back of the set it should give you the model number. |
19-01-2008 | Forgot Password of Hotel Mode | Pls let me know how i can reset the Password of My Oxygen 29 TV.
I am sorry to say but it must have been set by mistake and now we cannot recollect it .
i would appreciate if you could help me with the correct procedure and mal me on write |
19-01-2008 | Electronics removal | HI, I'm new and have a simple question. I have a very nice 25' GE console tv (25pm5888p) that no longer displays in the correct colors. I want to remove the TV from the cabnet and dispose of it, and re-use the cabinet.
Is there a shock danger in r |
19-01-2008 | repair manual of tvs msp 345 | can any one provide me the repair/service manual of msp 345 printer. the problem with my printer is that it is printing next page content also on the same page without changing to next page. kindly help. |
19-01-2008 | | Take a flat head screw driver and put an alligator clip on the screw driver metal and the other end to the metal wire on the back side of the picture tube and use the screw driver to pop the anode lead from the back of the picture tube and it should be sm |
19-01-2008 | | I have chnaged 2 capacitors ( 35v - 47uf & 50v- 4,7uf ) in the power supply ( primary ) near ther STR but nothing chage the voltage is the same. so what do i have to check or change , help plz |
19-01-2008 | HP ze4145 Touchpad | I need to replace the touchpad on my HP ze4145 notebook. Does anyone have steps needed for removal? Please send diagram to [email protected] Thanks !!! :) |
19-01-2008 | | it's too heavy for me to move with the stand all all of the equipment, i have been over the entire back with a flashlight and i can't find anything. |
19-01-2008 | Re: No Picture, No sound, clicking noise | [quote:0fba5aa815="jmpres"]Magnavox 32" TV model TP3272 C101 Chassis 32R502-00AA. When I plug the tv in it makes a continueous clicking sound. Cant turn TV on. No picture, No sound.
Any clues to what the problem is?[/quote:0fba5aa815]
If you pu |
19-01-2008 | JVC DVM-90 Digital Camcorder is powering down when playback | Hello friends,
I have a JVC digital video camera model DVM-90 that is having a problem.
When I use it for record my videos, It works fine, but when I try to play my recorded videos, sometimes it is reseting the power. It is a intermitent problem and |
19-01-2008 | I need service manual for CYTRONIC Viewpia TV | modele LC26IE11
For repair ( no power on ).
Many thanks.
:wink: |