|01-02-2010||programer top2048||i have eprom programmer top2048 and sudenly is no conection to usb..
and inside is an chip u5 and i think is litlle to hot than it supose to be..but the numbers on this chip is scrached down...so can you help me find what is this ic or were can i send th|
|02-02-2010||This Service manual can now be purchased for $11.77 and downloaded immediately after payment from:
The above manual covers your machine.
|02-02-2010||shivering lcd||Appreciate the reply, Torbjorn. Don't think it's the computer because I've tried it on different machines. But you may well be right about the power supply and I'll check that. I was hoping someone would point me in the right direction before I open it up|
|02-02-2010||If the supply has NO 12 volt or 24 volt supply, but does have the 5 volts standby source, the only thing necessary to get the supply to run is the control / enable / turn on signal (usually supplied by the control board after IT gets the On/Off command fr|
Saw a couple of possibilities. :D|
|02-02-2010||canovision 8, model e67 camcorder issues||when camcorder is on wavylines appear on viewfinder and tv when connected, and tape playback looks like a scrambled cable channel, its possible it has smd caps that have dried out, can't say for sure as i don't have a schematic for it.|
|02-02-2010||tv is shut down after 3 second||this tv broke my head :( .its chasis EW62B.having proccessor tda12020PQ/n3.I think it is LG as this chasis is put by a fixer inside anoder model.after connecting it to power it is STBY so when pushing PROg button i can here THT after 3 second it is shut|