| Date | Header | Text |
|---|
| 23-07-2009 | Heyyyy | Thanks man, checked regulator , output voltage was 4V, removed output pin from board still 4V. Changed and I now have a working TV Set.
Thanks |
| 23-07-2009 | | You're welcome. :D |
| 23-07-2009 | STR-KSL5 | when i push the dvd button it comes up DVD for about half a second then changes to UNLOCK, what does this mean and how can i unlock it? :|
does anybody have any ideas... |
| 23-07-2009 | | This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after payment from http://www.justmanuals.com
[email protected] |
| 23-07-2009 | | Convergence IC's and resistors. |
| 24-07-2009 | best replacement psu board | Alain, hope you are well. I must say I am impressed at your investagations regarding the power supply and IC’s on these viewsonic tv’s. I am beamik, you replied to my post on January 2008. forum.eserviceinfo.com/viewtopic.php?t=29325&postdays=0&po |
| 24-07-2009 | Stabilock 4015 | Do you have a service manual? |
| 24-07-2009 | Thanks for the help | Don't know if minnie is still around and will read this. I found this thread when my viewsonic N4060W died and I fixed it for under $10.00. Thanks for the info. |
| 24-07-2009 | DOWNLOAD FOR FREE!!!! DONT PAID!!!!!!! HERE..... | DOWNLOAD ALL CANON MANUALS SERVICE:
.sinopticdot.ro/DOWNLOAD.
OR
pdftown.com/Canon-iR1200-iR1300-Service-Manual
DONT PAID!!!! POR UN INTERNET 100% LIBRE!!!!!!!! NO JODA!!!!! |
| 24-07-2009 | labofuge 200 | hi where can i inquire about the labofuge 200 parts and repair here in the Philippines.
pls e mail me at [email protected]
thanks |
| 24-07-2009 | Goodmans LCD TV Power problem | Go directly to contact your Goodmans LCD TV supplier or support center. They have professional tools to detect the issues.
Many thanks for your suggestion but I do not know the supplier and I have tried Goodmans support centre and all they say it may b |
| 24-07-2009 | Yamaha RX-V795 | As Vetec said check all ground connection.The back panel plays a big roll in grounding in most of the Yamaha units. Check for DC offset,If you have it on any of the channels replace the roll-off caps.Solder connections on the bias transistors are also kno |
| 24-07-2009 | | Just use some cotton and alcohol to clean the sensor under recording paper.
It is located under the right side of scissors mechanism. |
| 24-07-2009 | PSU problem Infocus 5700 - heat up caps works | Hi all, I have an Infocus Screenplay 5700 projector with a PSU problem. It fails to startup unless I blast the power supply board with a hair dryer for 30 seconds or so. Then it runs just fine, until I power it off.
This, I have learnt , means I have a |
| 24-07-2009 | Parrot CK3100 Handsfree kit | Any advice greatly apreciated!
I have this handsfree kit in my car, which has wroked perfectly well with my Nokia phone for a number of years. I recently upgraded the software on my phone (Nokia 6500) to V 08.30 RM 240, which is now causing problems |
| 24-07-2009 | Maganavox 20MT1331/17 | I currently have no sound coming from this model. I do have a quality picture though. Pls offer your expert opinion re this problem. Thanks! :( |