I think sometimes my and your concern is same. I used to face the same problem doing log in. I talk to guy who is an I.T. Person. He told me that it is not a major fault. It happens sometimes to do high traffic and load on Internet. He advise|
|17-11-2009||Hitach 50EX14BV - fix or junk?||I just purchased a beautiful used Hitachi 50EX14BV rear projection tv. In the process of bringing it home, the morons (family) that transported it broke the clear shield & punched a hole in the screen. Is there any place to purchase a replacement, &am|
|17-11-2009||You think you're the first person with this problem? Do a search for other projos with a broken/cracked screen.
By the way it [b:7c157cb872]IS[/b:7c157cb872] usually SCREENS!
The technology between brands is quite similar: projection source > mirro|
|17-11-2009||yes,sound is ok|
|17-11-2009||BD3||Please I need your help for Diode BD3 component. I want to know how to check this diode through a multimeter.
|17-11-2009||With one end of diode disconnected (floating), with MultiMeter on diode test, No reading with test leads connected one way, reverse the leads and should now have a reading.|
|17-11-2009||My local electronics store can order the same: Evox Rifa PHE450MB5220JR06, 22 nF – 630V Dimensions: 5.5x10.5x18mm - pitch: 15mm
Minimum 5pcs at ˆ0,5 a piece.
I'll wait to order them until you confirm that everything is working again!
I can mail|
|17-11-2009||Re: how to unlock control lock of samtron 56v monitor ??||[quote="darshu"]hi
i have samtron 56 v monitor and i want to adjust contrast. but, whenever
i hit menu button, it shows me following message:
plz tell me how to unlock it ??
thanks.[/quote] :lol: :lol:|
|17-11-2009||Creative inspire 6.1 6700 Resistors keep frying||i have a creative inspire 6700. Two of the resistors had fried, R10 and R11. I replaced them(same resistors 5.6ohms) and powered the system back up. Fried the same two resistors in seconds. Is there something else i should look at replacing so it doesnt h|
|17-11-2009||The defective part(s)? :D|
|17-11-2009||display picture||Main board or panel failure look alike.the only way to tell is voltage measurements of the main board.But if you have sound,youre freind is probably right its the panel.Shop Jimmy sells used panels.Or you could find a parts tv on ebay.|
|17-11-2009||Re: my Panasonic NV-DS65 doesnt playback and doesnt record :||[quote="Sckorpion"]hello, so as i said Panasonic NV-DS65 camera would not play nor record!
i'm sure of the battery and the tape are perfect.
in VCR mode, I press play it plays the tape for about 5 seconds and then it stops automaticly and the |
|17-11-2009||I've tested it since yesterday for approximatly 6 hours. Everything seems ok. All inputs "ok", loudspeakers "ok". Several tests to start from standby without any problems and everything is now connected.|
|17-11-2009||Ok, but across the fat vertical line you can se horisontal lines ..... horizontal lines are across whole panel. If is paner bad , how horisontal lines can be displayed across vertical fat line ? I think bad panel block cant`t dispalyed notning ...|
|17-11-2009||Projection TV Yoke And Convergence Question||Does the tabs on the yokes have anything to do with changing the size of the picture? Cause I have a projection tv that the convergence knobs got knock out of alignment and the green tube use to be perfectly scanned before this happened, but now I cant ge|
|18-11-2009||Correct speakers for Sony STR-NX1 amplifier||I want to buy additional speakers for my Sony STR-NX1 amplifier to get as good a sound as i can get and currently i only have the "front speakers" which have an impedance of 6 ohms and there are outputs for "rear speakers" and "su|
|18-11-2009||volume stuck on Goodmans W322NS?||Hi everyone, just have a little problem with my tv.
I have a Goodmans W322NS. I discovered today that it would not allow me to higher the volume after a certain point on the volume bar. I used both remote controls, the Sky one and the original one that c|