|24-05-2008||Cash registers||Any one know where to get free service manuals for cash registers? I'm looking for a Sharp ER-3241 service manual.|
|24-05-2008||[quote:717e24180e="Anonymous"]Just making a guess here, do you try changing from cable to antenna to see if you get sound?[/quote:717e24180e]
tried it today and no sound direct to ariel either, strange as works through scart. Do you think it has som|
|24-05-2008||Do you get sound when you hook it up scart? If you do you have a bad tuner I would assume.|
|24-05-2008||Try posting int he decode/unlock forum. You'll need the serial #.|
|24-05-2008||I'm still thinking the dvd could be bad. Something could be wrong with the optics and it's only deciphering the signal.
It's only $39 here.|
|24-05-2008||Free is good until you can't, then what's worse you pay $15 for it and hit the wrong button and close your browser! :evil:|
|24-05-2008||[quote:461993b733="minnie"]Do you get sound when you hook it up scart? If you do you have a bad tuner I would assume.[/quote:461993b733]
yep get sound through scart, can tuner be replaced?|
|24-05-2008||I'm using the support bracket where an external wall mount would go.|
|24-05-2008||Earlier when I said
"With everything hooked up again, the Va and Vs reads 0v. "
that is essentially with the power off but the standby light on. When the YSUS is plugged in, the standby light will go from red to blue for about a second t|
|24-05-2008||But with them disconnected the voltages are not correct. How much do they want for the kit?|
|24-05-2008||With only the AC plug hooked up to the power board and supplying 118.7v, I get readings of 0v at the 5v, Va and Vs pins.
I am unable to find a kit. The YSUS and ZSUS boards are about $120 each, I'm not sure how much the control board is but the power |
|25-05-2008||After letting the Tv sit plugged in for a while, with only the AC hooked up to the power board, I get a reading of .024v across the pins.
The power button has no effect.
Also, I don't know that much about circuits and components but should the volta|
|25-05-2008||[quote:9ba32e6faf="minnie"]I'm still thinking the dvd could be bad. Something could be wrong with the optics and it's only deciphering the signal.
It's only $39 here.[/qu|
|25-05-2008||[quote:623c4ea051="Larbo"]Hmmm. I have to go to the in-laws (in their 90's!) to setup their new computer. I will have another go at it tomorrow and I will get back on this. Yes, diminishing return is just over the horizon. When I last opened it up, I had|
|25-05-2008||Let's see. Does the fact that the logo is broken up with no disc in the tray answer your query??|
|25-05-2008||[quote:dc2ae04812="Larbo"]Let's see. Does the fact that the logo is broken up with no disc in the tray answer your query??[/quote:dc2ae04812]
..even if you were to power down & back up again, yes it is definitely a signal board problem.|
|25-05-2008||[quote:a5c7cb989c="torbjorn"]Check that the vertical deflection coils are in order - no shorted turns, if there are two coils in parallel, make sure that there is not a open circuit in one of them.
Also, check the supply voltage to the vertical output (|
|25-05-2008||Yamaha AX 900 u trouble||Hi,first post here,hope i get this right..lol
I have a yamaha ax900u which i love and pounds..well,it did.....
somethin went wrong.....i can plug the rca jacks into any input and get only a very faint sound......the only thing that works is pluggin it i|
|25-05-2008||[quote:b6ed53cc37]yes it is definitely a signal board problem[/quote:b6ed53cc37]
Specifically, the board on the DVD assy? If that is the case, is that board available separately since the number I gave is just for the mechanism part??|
|25-05-2008||Depends if the other side of the resistor goes to ground. Sounds like the power supply also got hit. If your VA/VS is that low, I'm thinking it got hit. With load or no load the supply's are way to low. I'd suspect minimal power supply, Y sustain and Y dr|
|25-05-2008||Not familiar with sky box, assuming it's a satellite box. Is it a free view box or a subscribed box?|