|Bump-little help anyone?
|How to increase the KY bass level. In our TV the KY Bass level is just 45 and it is not increasing at all . Tell me how to increase it.
|The convergence IC's are on the "D" board. The D board is on the left hand side with the back off. They occupy the largest heat sink.
|As to where to obtain: here's two options
I need service manual for dvp-f25 sony dvd player.
|akura ABLDVD3220WHD sound problem
|my recently purchased akura abldvd3220whd has suddenly lost all sound. as the company i purchased it from has gone into liquidation (BDC) i have approached akura to fix under the manufacturers warranty. they say the warranty was purchased by BDC they can
|have just joined and the site looks great.
|This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after payment from http://www.justmanuals.com
|In Europe, it is common that more recent high-end CRT TVs use digital signal processing to double the vertical frequency to 100 Hz to decrease flicker in the picture. I don't think that technology is widely spread in 60 Hz countries, as a 60 Hz vertical f
|if you have a signal tracer you can check to see if you have audio input to the output ic. if no input, could be volume control ic. did you check for bad solder connections on the output ic or even the harness connector.
|[quote:8d29b75e1e="Justmanuals"]Well why don't you call them again and find out who REALLY manufactures it?
Thank you Paul,
I did called them many times, I event talk with their VP, they don't wants you t
|pioneer model sd-p403
|:D I am in need for a service manual for the mention big screen.It is a 1992 yr model.thankyou in advance.
Thanks for the reply. Once they come in and I put them on, are there any procedures that I need to follow to get this convergence back to normal? Should the flash focus work afterwards?
|[quote="Anonymous"][quote="minnie"]Replace the STK392-110's. Could be STK392-150's. Resister values:
Resistor Location Value Part #
RK42 3.3 Ω 1 W AT03202S
RK46 1.8 Ω 1 W AT03195S
RK50 3.3 Ω 1 W AT0320
|Do you have the info on RK97 That is the only one I need that you dont have
|When you have IC's pulled, check for open or changed value resistors in the same area.
Yes, flash focus should work again.
I have those IC's unscrewed but I'm having trouble actually REMOVING them from the board. I don't want to force it too much and risk breaking something-any suggestions you could provide to get those out? I haven't removed the heat sink bec
|Sorry for double posting but I just realized I need to pull this board out entirely and desolder the underside where those pins from the IC go in don't I? Argh. I am not electronically inclined. I might need a walkthrough here or a link to one if anyon
|Multimeter = YES Measure resistance of resistors and compare to value written on them.
Desolder = YES Always desolder first, then remove old device, replace with new device and solder.
Many "How to" videos on you tube.
|cd changer wiring
|Hi,can anyone tell me what this single thin wire does,it has been cut on the second hand changer ive bought,(see pic if I can upload image :oops: )if it failed it connects to the rear of a renault in dash cd changer opposite the long green connection [img