| Date | Header | Text |
|---|
| 19-12-2007 | rca hdlp60w151 color wheel help | I have decided to try to replace the color wheel myself. Anyone have basic instructions, or copy of relevant section of repair manual, on how to do this (including how to open the back of the unit). Is this a simple remove and replace of the old modu |
| 19-12-2007 | Service manual - Pioneer PD-M700 | Old (1989) :shock: 6 disc cd-changer
Need service manual or tip why changer won't register cd's.
Thanks
Jesper |
| 19-12-2007 | | Do the contrast and brightness settings influence the bulges? |
| 19-12-2007 | | Thanks for the answer!
I solve the problem. The CRT is the reason of all.
After i chk all and can not find any thing i do the next steps:
1. I connect a resistor 15k betw. 5 pin of TEA5101 /where is the 200v power suplay/ and GND. /I immitiate ~15mA |
| 19-12-2007 | Remove Hard Disk from Acer Aspire 1660 | Removing the hard disk from the laptop is easy. Just turn around the notebook and remove the battery. In the middle you'll now see a plastic latch. Just pull it towards you and you hold the hdd in your hands.
Regards,
ThinkPsy |
| 19-12-2007 | | the hv splitter? |
| 19-12-2007 | | No. Contrast and brightness does not influence it. |
| 19-12-2007 | Dell D1626HT monitor wavy lines | I like my big old monitor, but recently it has started exhibiting strange behavior. I suspect it is a cap.
I found the schematics online, so I have them.
The symptom is as follows.
The sides of the screen have squiggles. NOW:The strange thing.
On a n |
| 19-12-2007 | | Are you aware that you replied to a post thats over 2 years old?
I doubt if he still has the problem.
[email protected] |
| 19-12-2007 | bulging pic. | Looks like the vertical deflection has trouble,vert.output,power supply noisey,or the pin cushion, maybe in those areas somewhere... |
| 19-12-2007 | Where | Not to be dense but where is the best place to get the parts? |
| 19-12-2007 | Tek TDS460 | It's the same as U136 5 chips toward the back of the scope. Any luck finding a service manual? I too have the same scope. Mine won't boot. The lights are on but nobody's home! |
| 19-12-2007 | boseawr1-1w just loud hum | My bose just quit the 5 volt rail is at three volts ic u403 is warm.Think this devise is bad. Does anyone have a schematic for the radio...The ic in question is a toshiba tc9213p looks like its being used has an eq devise or balance devise..has anyone run |
| 19-12-2007 | | Try
http://www.matelectronics.com/ |
| 20-12-2007 | | I received an email from somebody suggesting that i open the unit and lightly tap the top of the plasma display panel above where the white line is. Does this sound feasible? This is the first plasma i've worked on, so its uncharted territory for me. Any |
| 20-12-2007 | Making a 13" TV bluetooth enabled | Hey everyone - looks like I've found the right place to ask this kind of question.
I've got a 13" TV in our exercise room that I want to make bluetooth enabled - we have 2 small kids and the exercise room can be like an echo chamber when I'm worki |
| 20-12-2007 | Television troubleshooting | Sony KV-30HS510 30" HDTV CRT TV set (2003). No onscreen static charge or video-audio. Standby light blinks 6 or 7 times (depending on which time it is plugged in) hesitates, then repeats. There is a typical power up thrum when it is first plugged in |
| 20-12-2007 | | It is a well known type of problem with some kinds of monitors. In the past, i have encountered it on Nokia 449 series as well as on some old AOC EGA monitors.
If the monitor has the horizontal deflection separated from the EHT supply, then the width |
| 20-12-2007 | | Then it seems like that the video signal contents influence the horizontal oscillator in some manner.
I remember that some old Finlux chassis had a double-side PCB without plated-through holes in the video area, the feedthroughs were made by soldering so |
| 20-12-2007 | polite answer to mankey | Lissen mankey- I have 30 years + in electronic repairs- obviously know more than me- to put it as simple as possible- the universal remote does basic functions such as change channels etc- once programmed by entering codes or by auto search- there you go- |
| 20-12-2007 | | A word of warning: many cheap, small televisions have a power supply that is not isolated from the electrical mains. This is usually true for the models that have no audio or video inputs/outputs at all, just an antenna connector.
On a such television, |
| 20-12-2007 | How to find a horizontal output transistor | Waa'l Pilgrim- yer could try praying to the Lord- it usually works(might take several years, decades etc- or you could look up your local friendly parts supplier- or did you mean whereabouts in the set the transistor is located?- waa,l, iffen yer have to |
| 20-12-2007 | toshiba notebook | please send to me service manual of toshiba notebook SA60-122 |
| 20-12-2007 | toshiba notebook | please send to me service manual of toshiba notebook SA60-122
Gr Harry |
| 20-12-2007 | Re: Audio10 BE6021 Unit I oredered-A Follow Up | Dear Mr. Brad Zing:
I would like to make a follow up for the Audio10 BE6021 I ordered from your office. I cannot reach you by phone/ email, I already sent you the payment for the radio [u:a546f6655d]twice[/u:a546f6655d] - the first one is for the paym |
| 20-12-2007 | problem | I have this problem with my Panasonic nv-ds65
[quote:bac344e06c]My panasonic mini DV camera ejected the tape and then made clicking sounds like the cogs jumping about 8 times then stoped since then the door will not stay closed and if I hit eject aga |
| 20-12-2007 | | Thanks for the tip.
If I put a voltmeter on those leads, what's a reading over which I'd need an isolation transformer? |
| 20-12-2007 | blue tooth | If you have the volume turned all the way down you should see 0(no voltage) as you turn the volume up,the meter should start showing some voltage,use the a/c input on your meter since audio is an a/c sine wave, depending on the wattage of your speaker am |