Date | Header | Text |
24-08-2009 | BPL TV MODEL BZR62ZA1 | I HAVE BPL TV MODEL BZR62ZA1 PIP,THE PROBLEM IS THAT TV POWER ON PROBLEM COMES AFTER 4-5 DAYS,POWER ON LED STARTS BLINKING AND DOES START.BUT BY KEEPING OFF FOR 15 DAYS ,IT BECOMES ON AFTER FEW MINUTES.PLEASE CAN YOU GIVE SOME ADVICE.
THANKS |
24-08-2009 | schematic daigram of bpl tv model BZR 62ZA1 | SIR, can some one please send me a schematic diagram of BPL TV model no. is BZR 62ZA1.
thanks |
24-08-2009 | Toshiba 32AV500U | my toshiba 32AV500U HDTV has green light but noting on the screen, what could posible wrong? Any suggestion, idea? please help, thanks |
24-08-2009 | | Same thing happened to me. Mine fell in a stream while on vacation. I took it apart and let it dry over fireplace but no luck. After I bought a new camera some time after, I went back to check on the old one and it was working. So if you wait until it dri |
24-08-2009 | Sony KP-48V75 | Anyone know where I can find the service manual?
The red light in front is blinking continually and I have black screen. The audio is ok but no video in any mode. |
24-08-2009 | Refurbished LCD boards | You can buy refurbished LCD boards of all makes at Partstore. |
24-08-2009 | Sound,no pic LCD | Check the power supply capacitors for bulged tops,If not the power supplyits probably the inverter boards |
24-08-2009 | HP 1702 Repair | Need repair info for HP 1702 Moniter that blinks on and than either off or turns completly off. Info is for elctronis repair class. thx |
24-08-2009 | ICs | Replace all three-Google Electronic Parts Distributors. |
24-08-2009 | ON/off Hitachi | Ive had 2 Hitachis,one Samsung,and an Apex GB5108 do this.Power supplies tested fine.I resoldered everything.checked the remote board,OK.The TVs should have stayed on.The convergence ICs were burnt where the pins go in.Replaced the ICs and the TVs worked. |
24-08-2009 | Capacitors | You can get 35 volt,1000 uf,105s at Mat Electronics.10 for $1 each. |
24-08-2009 | | Yes vtech is right. The bulge on those caps are normal. I cut the insulation and the metal underneath is flat and intact. So I resoldered new caps and the picture is the same. Below is a picture of the screen. Any idea which board is the most likely culpr |
24-08-2009 | | well that didn't work. What happened? bbcode is on. |
24-08-2009 | | Here's a larger pic if someone wants to copy and paste and have a look. Thanks
[img]http://images1f.snapfish.com/232323232%7Ffp935%3Enu%3D323%3B%3E3%3C%3A%3E%3B44%3EWSNRCG%3D328%3B%3A79762339nu0mrj[/img] |
24-08-2009 | | Also the lines at the top is normal. That's an old vcr on pause |