|:? hello; please i need the electrónic diagram of lecktor cd pioneer model CMX-5000, in my island havent technics service SOS :oops:
|I found that the supply is also based on a integrat circuit UC 3842, and R118 goes to the Drena of moseft, and R119, goes to pin 3 of the IC mentioned above.
|Sony Handycam DCR TRV280 error C:31:22 when i insert tape
I need ur help about my sony handycam, when i insert a tape a beep comes out and it say ReInset the Tape and i see in the view finder a message C:31:22. Any help are highly appriciated. Thanks in Advance
|I installed the new vert i/c today with no improvement.
I highly suspect it is the transistor I mentioned before.
The transistors unfortunatly are on back order and hope-
fully not obsolete. I will keep you posted, thanks for the help.
|Re: ### URGENT EPSON R210 REPAIRS ###
|gud day..try to pull out the pump unit it easy to repair or put that if you pull it out the pump unit..and look for the missing spring...
peter of iloilo
|AOC spectrum 7GLrA, no Color Display
|I have a "AOC spectrum 7GLrA" monitor, the problem is No display or even a small fliker on the screen when turning ON. the Relay seems to be working i can hear and feel the switching when turning ON, the LED above the power switch is lighting al
|tevion tv has blue screen and red padlock any ideas how to get rid of it
|need a schematic for yamaha rx-v390 rds
|need a schematic for yamaha rx-v390 rds
|me too :(
|Re: NOKIA2130HS-service mode?.
|hi about the service mode for the nokia chassis try mute m i ,or i m prog or -- menu tv [/list][/code]
|IT IS LOCKED, I HAVE 74 MODELS LISTED IN MY DATABASE. WHAT MODEL IS YOURS.
|Does the OSD (On Screen Display) work? Have you tested the videocard in your computer by plugging another monitor into it??
|Very Valuable? Maybe you should have a backup copy?
|You may need a different powerswitch, or an ATX case, as the AT switches the mains on and off. Replace this with a momentary microswitch wired to the powerswitch connectors on the motherboard.
|Maybe the ac adapter is not charging enough? I think they are 13.8 volts @ 3 or 4 amps. Can you load test it?
|Have you tested the electrolytic capacitors? These dry up with age and cause noise on the supplies to the chips. Replace them with high temperature (105degC) low ESR ones.
|Reques a service manual for the Toshiba 300 CDS Satellite
|Experiencing monitor/or vid problems. Getting lines running from left to right from top half of screen. Need to access vid card, maybe to clean the ends. Might be a bad card now but maybe just cleaning the ends may help, or could be screen itself.
|I'm turning one Printer Epson LX-800 into one b-printer
|I need to slow down the carriage or all the printer mecanism in order to
use one device that marks points in the paper, the current problem is
the huge speed of the carriage, even in NLQ (450 PPS speed) is to fast,
is there any way to make it slowdown
|I HAVE SOUND BUT A ROLLING PICTURE. WHAT TO DO???? PLEASE HELP
|need service manuals denon UCDM-700
|hi i have a trouble whit UDCM-700 i blow the transistor after aa few minutes when playing a cd my amp. up to 3 amp i need the service manual for test the voltage
|Need schematic for oscilloscope LG OS-5020
I need the schematic for the LG / Goldstar OS-5020
|re: need Asus L3C and Clevo NB schematic diagram
Does any have notebook schematic Diagram for Asus L3c or clevo 2200c
or any brand also can.
I have a ASUS L3C keep shut down after on for 1/2 hr totally no power then press power botton can start again for awhile.
Anather Clevo 2200c Work
|RE: Daewoo eject Problem
|I have the same model and it is doing the same thing, ejects but leaves tape hanging from cassette. Did you find a solution?
|Sorry I forgot my contact info; [email protected]
|how much will be tyhe coast for 10000 nokia 6600 in usd
|Thanks very much for replying :D . One thing I'm not sure of is how do you tell if the tube is 110 or 90 degree? It is 28". :?:
|I don't know this chassis but I had once similar problems with a cuc5511.
Then the problem was a short circuited BU 508A line oscillator.
After replacement the power supply could start up again
|sony kv25fx30 its dead, led flashing 11 times
I have a Sony KV-25FX30E to repair. Its dead and when try to start the led flashing 11 times. 5V are ok and the relay goes ok.
Thanks in advance
|Panasonic tx-32DK20f(Euro 4h chassis) and red picture.
|My problem is that the tv's picture is too red. It is clearly visible when the picture has black background. The picture also has these lines horizontally from left to little pupper right.
|if the set is an 11ak45 problem could be dry joints on lopt
|I was about to buy one of the new Instek programmable Function Generators when I noticed that the resolution of the output was 10mv
I was hoping to be able to set : 20kHz @ 42mv p-p
If this is the case, I have seen small plugin attenuators that I ca
|WANTED TECHNICIAN ELECTRONICS FOR REPAIR GSM
|WANTED TECHNICIAN ELECTRONICS (level good) FOR REPAIR GSM
for my factory in PARIS FRANCE
if you interested contact me:
|Re: Need Service Manual for JVC AVG29MX Television
ANYONE OUT THERE WHO HAS A SERVICE MANUAL FOR JVC AVG29MX?
i have av g29mx circuit diagram i give you[/quote:211a7b9722][list:211a
|Am I spam ?
|Your post is marked as spam. Your ip and proxy ip are blacklisted.
If you feel this is not right, please, contact support et eserviceinfo.com with spam report id 81
Give as detailed information as possible.
Posibly someone from my subnetwork was bann
|That's mine and i need it too.
Mine is a compaq presario r3458ea, with am64 3200+ mobile. 1 Giga Ram, 80 G HD, nvidia geforce go 64M.
Could anybody help me?, i´m very interested in knowing all about the hardware inside this great machine.
|Hello i had a 29fx30 with the same problem and the pro was ic 604 i think (regulator 5 pin--ba41w125t)also this could be 4 capasitor in the ic 601 _mcz 3001d and the ic 601 sometimes good luck
|Re: my Panasonic NV-DS65 doesnt playback and doesnt record :
|[quote:e993bd864a="Sckorpion"]hello, so as i said Panasonic NV-DS65 camera would not play nor record!
i'm sure of the battery and the tape are perfect.
in VCR mode, I press play it plays the tape for about 5 seconds and then it stops automaticly and the
|Hello masters of electronics.
I need to make a circuit that will repeat whatever is said into it after a few seconds.
If i sound ambiguous, then example of this thing can be taken from those teddy bear toys, where your press a button say something, and