Date | Header | Text |
27-12-2009 | | Actualy, I was not loged :oops: in so my post is submited as guest, my user name is krumora3 |
27-12-2009 | Hardware problem with my mp3 player? | Hello,
I have a simple 1GB flash mp3 player, the one with the 7 different display colors.
When I plug in the player to a computer, nothing happens (it doesn't appear when I go to "my computer").
If I put a battery in it, it turns on, but no t |
27-12-2009 | | Good 'old SV5000W....I'll try to help you as I used to work with them all the time. Why not pick out a nickname & register first?
Since I no longer have access to any of the units, depending on your technical ability, I may ask you to post a picture |
27-12-2009 | | Thank you very much for responding. I registered as you asked me. I am an EE, so I will hopefully understand what you are telling me without much difficulty. I do not have a problem with soldering or running wires.
Awaiting further instructions. :-)
|
27-12-2009 | JVC GR-DVL367EK Camcorder | Hi
Would appreaciate any help in locating a service manual for the JVC GR-DVL367EK Camcorder.
Thanks for helping. |
27-12-2009 | Hex Code for a Logic 22" TV | Hi Guys.
Does anyone know the Hex Code for the LOGIK L22LID648
I'm trying to configure one with a Harmony Remote.
Thanks
Robert |
27-12-2009 | | Ok, I am not here all the time but will check frequently;
The loose ground issue was mainly due to a cracked solder joint on the main pcb right underneath the connector for cylinder motor. Due to the stress against the connector, it will eventually crack |
27-12-2009 | need help | i have a hitashi projection t.v the takes a lamp. which i have replaced, before the lamp burnt out the t.v was working very well, not i cannot get a signal,no matter what i do, i do not have the oridginal remote, so can anyone point me in the right dirrec |
27-12-2009 | | You'd need the main board out of the plastic case by following the removal sequence; I'll post more later after your response.
[img:79715199da]http://i67.photobucket.com/albums/h287/rramani/1-2.jpg[/img:79715199da]
[img:79715199da]http://i67.photo |
27-12-2009 | | And the model number is? |
28-12-2009 | | You can find the JVC GR-DVL367EK service manual at www.schematics.me |
28-12-2009 | | Thanks.
I checked but they dont have it.
Thanks for reply |
28-12-2009 | | It is there. Look again. Go to www.schematics.me and click on Camera and then JVC.
Or go directly to this link:
http://www.schematics.me/index.php?view=add_to_cart&id=21164&cat=15&brand=26 |
28-12-2009 | | Sorry I could not respond earlier, other things got in the way. I am now at the last step. Those two tabs are a little bit stiff but I am hoping to get them off after some jiggling.
Please post the rest of the instructions.
Thank you for your time a |
28-12-2009 | | The main problem is within the red circle on the main pcb . If you look close, you will likely notice cracked soldered joints at arrows shown..... While you have it opened, you should check other areas in blue and resolder if needed & watch out not t |
28-12-2009 | | try this
elektrotanya.com
akhtar z |