Date | Header | Text |
20-06-2012 | HP monitor 2310m | I have an HP 2310m monitor with the exact same problem-- image goes blank after about 2 seconds after power-on. Very repeatable, but a small percentage of attempts does result in it staying on with video-- it will stay on with no problem-- but if you |
21-06-2012 | | You are right I stand corrected.
Would you know the kit for the vertcal claps kit?
This is what I think it is Three capacitors 3300mf,25v 1000mf,25v 220mf,25v IC TDA8172 2.resistors R14508 R14509 think. what other components should I be looking could |
21-06-2012 | | One (or more) of these should suffice ("TRAINNING"):
[url]http://elektrotanya.com/?q=showresult&what=CTC203&kategoria=&kat2=all[/url]
collapse = claps |
21-06-2012 | CAT - AV Power Amplifier | Hello I hope someone can help me I have a problem with my CAT AV PA model CS-907. The problem is that when I power it on, the welcome message blink's few times and then it freezeees. Standby and reset butons don't respond. Thank you I appreciate your help |
21-06-2012 | Sanyo DP46849 pinout question | I am in need of the pinout designation for a Sanyo DP46849 Mainboard meaning what each pin does please
Thank you
Electronic surplus |
21-06-2012 | Re: Need help reparing a 37 inch Vizio vx37L- hdtv 10a | Check for U33 on the mainboard. It is a small surface mounted transistor replace it and your television will work again
[quote:d1401fed28="Carlos M."]The other day i went to turn on my t.v and it did not turn on. The sound and the picture did not com |
21-06-2012 | Re: Sanyo Dp 42849 | You need to replace the inverters. They are on each side of the tv. Master and slave
Before replacing them make sure the small smd fuses are good
jon
Electronic Surplus
[quote:521a53d77b="[email protected]"]I have a Sanyo dp-42849 and |
21-06-2012 | Re: Power Supply Didn't Work For Me | Sanyo LCD commonly have faulty main boards
The proper way to determine whether your problem is either is to check the voltages coming from the main board 5Volt Standby. IF, you have 5V, then chances are your power supply is good
Many times the Main Bo |
22-06-2012 | | [url]http://elektrotanya.com/cat_cs-907_sch.pdf/download.html[/url] |
22-06-2012 | | Replace all three cap the one 300 ohm resistor and the vertical IC still has a horizontal claps.
Need help please |
22-06-2012 | | Voltage measurements on IC pins:
1. Inverting Output
2. Supply Voltage
3. Flyback Generator
4. Ground or Negative Supply
5. Output
6. Output Stage Supply
7. Non-inverting Input |