|26-01-2009||Re: Help Magnavox Projection TV Dead...||[quote:a3237e910b="bob"]Hello
Please help me i have a magnavox 56" and i want nothing more then to fix it.
Model #6p5451 C101, Chassis #ptv750 ah01
When i say Dead i mean it. There is no clicking or even a led on. I checked all the easy st|
I'm looking for the service manual for an Acer FP855 monitor. I have reapired it several times when some of the big power supply capacitors blew, but a recent power failure seems to have grapped up the power supply in a more fundamental way. If a|
I'm looking for the service manual for an Acer FP855 monitor. I have reapired it several times when some of the big power supply capacitors blew, but a recent power failure seems to have grapped up the power supply in a more fundamental way. If an|
|26-01-2009||GERICOM TV/LCD model GTW 32" HD AU||I am repairing a TV/LCD GERICOM GTW 32" HD AU
It developped an intermittant on the screen>
After 2min of normal displaying excellent picture
vertical coloured lines all over the screen show up
this picture freezes
no response to remo|
|26-01-2009||Service manual Sony KP53HS30||Need service manual for Sony KP53HS30 please. Thanks in advance for assistance with this.|
Repair kits are all over the internet.|
|26-01-2009||It's a 5.6 k ohm resistor. Verify the model number. I'm not pulling anything up.|
|26-01-2009||BUT, it sounds like your convergence ic's are starting to fail. Convergence doesn't just 'drift.'|
Wow, this is an oldie. 3 STK4274 would be correct.|
|26-01-2009||This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after payment from http://www.justmanuals.com
The model number for the TV (on back) is: 50SBX70B
Serial Number: V71003083
Is there another number somewhere (for the motherboard) or something?|
|26-01-2009||IC805 is 12 volt regulator.
In a prior post you said you put a 13.5 (external) to pin1 and output (pin #3) reads 12.1 volts.
Now you're saying with pin 3 disconnected you have input voltage (14.5 at C816) to this regulator.
I'm confused. Was pin #3 f|
|26-01-2009||I don't know.
Here in the US, when a remote is broken, lost, eaten by the dog, etc. sometimes you can get a "universal" remote (best if is SAME brand as TV) that has "menu" and "navigation" buttons to work set.|
|27-01-2009||Ok, R992 is associated with the B+ line. Check E994 and see if it's open.|
|27-01-2009||Hitachi 51UWX20B - No picture or sound...||I have a 6 yr old Hitachi 51UWX20B Rear Projection TV that was working perfectly until the red recently went out of convergence. Replaced the two STK392-110 ICʼs with two STK392-150 ICʼs, plus a number of resistors. Checked all resistors with a |
|27-01-2009||Aiwa XG-330 Strasser||Any service manual for aiwa-XG 330? My problem is the main amp (STK-4132II) it always shutting down, I replaced it twice but still the same as defective..anyone can help me?|
|27-01-2009||HP mother(system)board from xw4600||Hi guys!
Anyone has an idea where to get schematics/diagrams for HP motherboard from Workstation xw4600? MB ID "fmb-0702 e93839"
And it's not HP web, their technicians actually refused to help me, because "it's not to be sold separate|
|27-01-2009||These diagrams are not available. Even the HP service manuals do not contain motherboard diagrams or schematics. Actually none of the manufacturers include schematics for motherboards.
|27-01-2009||aiwa c201||i found the SR2M doide is short and the STR 58041 has problem.But the 2sd1555(H-Out) is found good.I replaced both these components to a new one and powered on.The set run for 10 minutes and again back to the same stage.(SR2M short and STR 58041).What is|
|27-01-2009||sony 3400 v2||i got a sony 3400 v2.chasis is SCC-C29E-A.The picture is wavy.I found one of the filter capacitor C619(850mfd/250v) is getting too much heat and causing problem and one of the resistor 330k has gone high value.Replaced both the filter capacitor in the pow|
|27-01-2009||Do not have the specific schematic, but if you want to check on the STK4132II, there is a data sheet (with sample protection) that can be used as a reference.
|27-01-2009||1) Installed Backwards.|
|27-01-2009||sony 3400v2||the capacitor is installed correctly.but it is getting too much heat and the fuse blows off.|
|27-01-2009||Koss C-328||I am trying to find any servic manual or schematic for this home theater component. I have had it for awhile and would like to repair it. Thanks for any and all help with this.
|27-01-2009||2) Exceeds Voltage Rating of Capacitor.|