| Date | Header | Text |
|---|
| 13-10-2008 | | Thanks for that, but was hoping for a bit of free advice on how to remove the back. |
| 13-10-2008 | | The resistor fries because the IC's fail. |
| 13-10-2008 | | Can you post a picture? |
| 13-10-2008 | | Need a full model number. |
| 13-10-2008 | Did some searching...no luck yet....Akai TV | Hey all.......I heard this is a great site....enoughtobedangerous sent me!
I have an Akai LCT 37Z6TA TV that is only showing a blue screen with the words "No Signal" in the top right corner. Remote does nothing, side buttons on TV do nothing |
| 13-10-2008 | philips lcos picture problems | i have a 55 inch philips lcos tv with a shadow in all four corners of the picture anyone have any idea |
| 13-10-2008 | | I'd say signal board. |
| 14-10-2008 | Blue Screen of Death | How could two TV's both do the same thing at the same time with the blue screen of death. Both TV's are on the same system in the building. :roll: |
| 14-10-2008 | Re: Blue Screen of Death | [quote:801de5f9ed="enough2bdangerous"]How could two TV's both do the same thing at the same time with the blue screen of death. Both TV's are on the same system in the building. :roll:[/quote:801de5f9ed]
I posted back, where does it say two separate s |
| 14-10-2008 | Looking for Service Manual for Sony Str-DB840 (Receiver) | hi...
i need this manual to repair my receiver.
the problem is, that i cannot decompress this here:
w ww..eserviceinfo.com/downloadsm/36003/sony_sony%20str-db840.html
9 parts, but it doesnt work correctly with winzip or 7zip.
mfg |
| 14-10-2008 | samsung rptv probs | It is likely that your probs are due to digital convergence mis- when STK,s are r/p also is need to adjust digi converge(thru remote in service mode). Would need info to do- generally enter service mode, adjust converge, exit.A likely source of such info |
| 14-10-2008 | Sony LBT-A590 Amplifier problem | I get sound for about 5min and then the speaker protection relay sitches off. If I switch the Amp off and then on again it will give me sound for a short while then swithes off again. The longer I leave it off, the longer I get sound. I know it must be he |
| 14-10-2008 | | This Parts & Service manual can now be purchased for $9.99 and downloaded immediately after payment from http://www.justmanuals.com
[email protected] |
| 14-10-2008 | need service manual for TECHNICS SA-GX710 very urgently | 90's one of the toppest models from TECHNICS is under repair. For servicing this top model i need the service manual urgently can anybody upload this manual please. This is dolby prologic FM/AM receiver AV receiver with graphic equalizers with 5 chanel ou |
| 14-10-2008 | Benq DV2680 LCD TV backlight goes out in a minute | I need help in fixing this set. After about a minute the backlight goes out. Sound is ok. Power indicator is still on. I checked the usual things, power supply, caps, bad connections, etc. There is no red color in the backlight as you may get with backlig |
| 14-10-2008 | Sharp LC-32DA5U LCD TV with red vertical lines | I have a Sharp LC-32DA5U that works well except the screen has these red vertical slanted lines all over the screen, about 3/8" apart. Not continous lines. I would post a pic if someone would tell me how. Would like to know which board to look at and |
| 14-10-2008 | service manual | i am looking for service manual of viewsonic model N1900W,vcc inv.is ok,remote backlight on/off is ok,backlight is on for 4-5 seconds after that the unit goes on stand by mode i have checked everything on inverter/power supply board |
| 14-10-2008 | | http://photobucket.com/
Sounds like a bad T-Conn or panel. |
| 14-10-2008 | Re: Blue Screen of Death | [quote:641c689429="minnie"][quote:641c689429="enough2bdangerous"]How could two TV's both do the same thing at the same time with the blue screen of death. Both TV's are on the same system in the building. :roll:[/quote:641c689429]
I posted back, where |
| 14-10-2008 | | Hold a flash light up to the screen and verify you still have a picture.
BenQ America Corp.
15375 Barranca
Suite A205
Irvine, CA 92618
U.S.A.
Tel: +1-949-255-9500. |
| 14-10-2008 | help with pin outs on DC input, Sony CCTV Cam CV-710 NDC | Have a 6-pin mini DIN connector on the camera, and need to wire the mating connnector (from a 12vDC supply).
Have determined the chassis ground, but am unsure of the rest. Have 76 ohms across the ground pin and 2 separate pins. Open loop on the rest |
| 14-10-2008 | | I've got the AX-710 Parts & Service manuals here:
http://www.justmanuals.com/technics-stereo-receiver-saax710-parts-service-p-21134.html
[email protected] |