Date | Header | Text |
23-09-2007 | | http://www.partstore.com/sl/2/187162-hitachi-cz00865-strf6629b-lf1351-cz00865.html |
23-09-2007 | | Could also be convergence IC's. |
23-09-2007 | Toshiba TZ55x71 cobwebs | :roll: Toshiba TZ55x71 (rear projection): How do you remove front screen to clean cob webs out? |
23-09-2007 | | Pull The speaker grill off, locate screws @ bottom, disconnect any wires going to the screen via the front panel, grab the sides evenly and lift up. |
23-09-2007 | hourglass picture | I have a 1994 zenith projection tv, pv4663mk and sometimes the picture goes in on the left and right side of the tv. It is kind of like an hour glass. If I pick up the tv an inch and drop it, the picture sometimes pops back to normal. Any Ideas? |
23-09-2007 | | remove deflection pcb and check for poor solder connections around flyback and horizontal output transistor. |
23-09-2007 | | yes i did use that, ive got it right in front of me, did i make matters worse usein that and just cause more headaches for myself? |
24-09-2007 | ar-304 remote codes | My Ar-304 remote stoppe working, I am not sure if it is the unit or the remote. Does anyone have the remote codes in a file that I can use with a universal remote?
please reply [email protected] |
24-09-2007 | Toshiba Rear Projection _ Keep Reseting RED LED | Hello, Does anyone have any information on how to service an old 97 Toshiba rear projection TV? Everytime I turn it on, it click and then unclick like self protection circuit kick in. I've pull the board out and confirm that the PowerCircuit is doing th |
24-09-2007 | | Do you have the service manual for Harman Kardon avr330 ?
It would help me a lot
Roger |
24-09-2007 | | Well Duh! What's the model number? :?: |
24-09-2007 | I don't have the Sony part number | The Sony Service Manual for this model does not give the Sony part number for IC603 as it should not be required for the cost-reduced FE-2D chassis. I just bought an industry standard +8V 500ma 3-terminal voltage regulator in a TO220 case (TS78M08CZ) from |
24-09-2007 | | Unfortunately I took the boards out and the TV is not with me. I am just looking for general help if anyone has seen this. It's an old Projection TV that I bought back in 97 from Toshiba. It's 61" screen. The circuit board is a typical older d |
24-09-2007 | kv-28wf1e 2 blinks led | Hi,
I have the above Sony tv and it wont start up, I get the initial start up burst but then the audible click and the led blinks twice which means overcurrent protection.
Can anyone advise how I can fix this in easy terms please ?
thanks |
24-09-2007 | | CHECK THE LINE OUTPUT TRANSISTOR Q533 FOR SHORT CIRCUIT, IF IT IS SHORT REPLACE WITH GENUINE SONY TYPE ONLY, ALSO REPLACE THE LINE OUTPUT TRANSFORMER, R518 MAY ALSO HAVE BEEN DAMAGED IN THE BEAM LIMITER CIRCUIT, IT IS ALSO POSSIBLE THERE MAY BE SOME DAMAG |
24-09-2007 | UDM3 No control of volume | Does anyone have a schematic for the Denon UDM3. The volume is off at 00 comes on at 01 and then stays at the same low level when the volume control is increased or the remote vol up is pressed. Any ideas? |
24-09-2007 | | The original post is 2 years old, I would guess that he already got it fixed.
[email protected] |
24-09-2007 | cd-80 tuneing help | Hi all i have just got another car a rover 25 03 reg , the cd/radio player which is a cd-80 works fine but i cannot fathom out how to set the stations on the radio as i dont have a manual can somebody help !! |
24-09-2007 | PIONEER REAR PROJECTION SD-P4575 | I have a Pioneer Rear Projection SD-P4575 television.
The colours arent lined up anymore. It slopes on the top left hand side. I tried going in the menu and adjusting it there but that didnt work. I opened the back of the tv up and placed a piece of pa |