| Date | Header | Text |
|---|
| 26-12-2008 | | used to work on many Sony's--don't recall anything specific on the cassette housing timing marks....can you post a picture or be more specific?
Working of my memory, that was one of the oldies that used a separate motor on the cassette housing and if I |
| 26-12-2008 | CIRCUT DIGRAM FOR SONY TV KV-G21Q1& FORGET MY EMAILL | SORRY FOR FRGETING MY EMAILL PLEASE SEND IT AT [email protected] |
| 26-12-2008 | Service Manual TV Sony KV 1416E Chassis XE-3 | Hello,
i am looking for the service manual for sony chassis tv xe-3.
Can anybody help me? |
| 26-12-2008 | acer 9300 aspire schematic motherboard nedded. | urgently need the diagram where the power cord plugs(power supply) cheers. |
| 26-12-2008 | Re: what other brands ... | [quote:3dde50b4cc="jts1957"]Some Zenith's were made by JVC.[/quote:3dde50b4cc]
Also can you please tell me where in the chassi is the battery or cap that keep the clock on when the power plug is taken out of the wall so i don't have to adjust the clock |
| 26-12-2008 | | This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after payment from http://www.justmanuals.com
[email protected] |
| 27-12-2008 | Is this really the same convergence fault? | I also have a 42H81 projection TV that has the two vertical lines spaced on the thirds. The lines are only appear after the TV has warmed up. It has been months since the problem showed up but I have ignored it because it was only a problem with the DVD p |
| 27-12-2008 | | Sounds like the hyper board caps #23786198 ( MVPU13 PD0264A). |
| 27-12-2008 | | Update - requerst for help :-)
K, after poking around and checking all the fuses, ps etc, I attached the diodes in the power supply board. I found d6903 to be bad (shorted). Its a "10ERB20-TB3" DIODE. I have hunted for replacements but noithi |
| 27-12-2008 | | also, to add to the top.... checked the diode that dropped off and its still good..... ummm... wonder what that mean??? |
| 27-12-2008 | | This is turning more into a blog :-) Anwyay, I'm thinking of replacing the diode with a generic UF4003 Untra Fast (50ns compared to 60ns) 200v 1A diode. Thinking if this one doesnt heat up then it'll be fixed. Does anyone think this diode is not right? On |
| 27-12-2008 | Nordmende Carmen 57 Service Manual | Hello, fellow antique radio friends.
I recently inherited the Nordmende Carmen 57 radio. It has been kept in good to excellent condition. But was stored in a clean place for about three years. I need to give it a good check over and cleaning before I act |
| 27-12-2008 | | Matt,
Well done in finding the diode! ;
Keep in mind, when dealing with switching power supplies, all scan diodes are almost always fast switching, in this case, while the breakdown voltage & amperage between 1N4004 & 10ERB20 are similar, the re |
| 27-12-2008 | Dead chips in ribbon cables | I got one of these in for repair with the exact same fault. I can confirm that the fault is to do with the chips in the ribbon cables attached to the display. I found that the chips that corresponded to the areas of the screen with the white bars were bur |
| 27-12-2008 | | have found a manual for this now but no schematic/circuit diagram :cry:
its this manual
chassis
GED32SE
GND32SE
GED40SE
GND40SE
GND46SE
model
|
| 27-12-2008 | | Hi Ray, thanks again for your valuable feedback. Hope to carry some good news tomorrow when I pick up and solder the part on. Going to go with uf-4004 as suggested. The other parts you recommend isnt easily avaliable in Nz (as far as I can tell) and so i' |