|In case anybody cares
Fixed my Interlude IL60. Both sub-woofers died within about three months of each other
Problem traced to R509 (100k 1/2W resistor) in the BASH power supply board.
In both subs, this resistor had gone open circuit. Replacin
|So much for the tech, took the board out and checked the chips and he missed out solding about 6 of the pins.
Now all pins solded and fuses checked. they are all fine.
Though I can not find the FD101 or FD102
Would it be worth replacing the red a
|Sanyo CD player stuck in standby mode
|I have a Sanyo MCD ZX700F Radio/CD player which is stuck in standby mode. I've tried pressing the reset button but still it won't turn on. Can anyone help? Many thanks.
RSSPMF 3-1/2 3-1/2A 125V PICO MICRO FU $1.88
|You have a degaussing problem. The TV does this each time you turn it on when it's cold. Try turning it on and off 3/4 times. If that doesn't work, you may have to do it manually even though Sony says never to do that.
|did you found any sollution to your problem?
I am having the same problem as you, What is going on with Seagate?
Please write :D
and thank you. But if I order from the USA, it will probably take about a week or 2 to get here and may be cheaper and easier here in the Uk :-)
After going through every single fuse round the STK's, all are fine.
|found them :D
Axial Fuse 3.5A 125V pack of 5, luckily the same place I ordered my STK's so they can add them into the package.
Wish my husband luck (he is the solder of the house)
|yeah, I figured someone here would have seen it though I couldn't find any documentation about it. The Sony plays its own recordings just fine, they're of lousy quality though. I should have got one from an era where recording quality was more important i
|I would say you have a fault in the the crt video amp board in the neck of the tub1e.
|Panasonic SA-AK600 Mini HiFi
|I need help! I replaced the audio ic RSN311W64B-P due to audio output (centre out) speaker fault. I now find the unit not powering up. It is on permanent standby mode - No i/p or o/p connections ... any suggestions..?
|Now, did you take a multimeter and check them or are you going by the way they look?
|Orion Television schematic needed
|Does anyone know of a web site that might have a schematic and/or a service manual for an Orion TV - model-TVCR1900AC?[/b]
|I have this same problem with mine. Did you ever get it fixed? Do you have a manual for this tv or any kind of schematic?
thanks in advance
|sony kv-36xbr800 HELP!
|Hello When the tv is turned on the screen starts by being white with small whiter lines across the screen, the screen keeps getting brighter and brighter until the tv turns it's self off. Can anyone help me which board or part to replace?
|AKAI AMU310 ST AMP
|NEED A C/DI FOR A AKAI AMP MOD AM-U310 CAN SOME ONE HELP.
|if it was partly working before replacing chip double check for solder bridges and splashes this is a situation that as happened to all of us at some time
|PANASONIC SA-AK600 Mini HiFi
|Thanks tsgunnell. I have gone thru' that. If you are familiar with the cct of this unit (no disrespect) - the ac transformer cct is not being activated 'coz there is nothing coming from the uP to activate the relay (via a switching tranny). VCC and VREF o
|search in zarekmanuals.com
|We checked them all using a multimeter.
|Some non-english forums appear to suggest that it is better to replace 1.5nF 2kV (HR R 152k 2kV CM92) with a 1.5nF 3kV capacitor. Should I assume that there is no harm, if not better in using the later?
Is it necessary to use cermic capaictor of the ty
|Same problem with my nsx-av320
|Hi, did you get your nsx-av320 to work, because mine has a similar problem...all power amps seem good but no sound...it seems to be muting !
|support for canon np 7161 photocopier
|hello ladies and gentlemen
I have recently bought canon np 7161 photocopier machine.Now surprisingly, it jams paper frequently; when paper feeds from the tray it will stop automatically. Please give me genuine reply.
with best regards,
hope that helps.
Can you get me a jeep cherokee code????!!!!
|Some problems with old TV
|Hello all, I have an old TV (model "Tesla Color 110 ST"), which still works okay, but recently some problem started to appear: the TV works fine, until a there is a completely black screen (e.g. transition between ads). Then the TV emits a serie
|This Parts & Service manual can now be purchased for $10.79 and downloaded immediately after payment from http://www.justmanuals.com
|thanks bro 8) but the schematic costs money :roll:
|Blaupunkt/Renault code and how to help please.
I have tried searching but can not find the answer :?
I have a Renault G5 Blaupunkt stereo, i think i have the correct code but have no idea how to enter it.
Can anyone please confirm the code and tell me how to enter it? I know how to g
|All resistors around the IC'S?
|This white line in the center of the screen?
yes. Tomorrow we will check the fuses under the IC's and hopefully find replacements for them, as if they are under the heat sink then these we have not yet been able to check.
So plan for tomorrow is:
Check the fuses under the heatsink, replace
|LOOKING FOR MANUFACTURERS PART NUMBER
|I'm looking for the manufacturers part number for an IC thats used in an Adcom tuner/preamp GTP-500/2.The only number listed on the schematic and on the part is the Adcom part number .The IC is an op-amp and the number given for it is Adcom7AA.
|did you have any luck finding one online,, a download?
|hi changing the wires over worked a treat many thanks....
|Re: memory loss
|[quote:4a5edf61a9="techpubdonkey"]hi thanks for the tip i will try this . thanks[/quote:4a5edf61a9] hi there swapping the red and yellow worked a treat .. many thanks...
|Get a solder tool and start to resolder every thing in the horizontal and vertical also resolder fly, good luck,
|hi there need some advice. i have a hotpoint washing machine wma11 first edition. when spinning in the fast spin machine sounds as if the bearings are badly worn in the drum. also when turning the drum by hand the bearings are noisy. i have looked at th
|I use this site,
|AKAI 42" Plasma HDTV PDP4225M User Manual
Can some one please upload the above manual for AKAI PDP4225M user manual or at least point me to a URL or site where I can obtain that.
Thanks in advance.
|I too, am looking for an instruction manual to the BR 532, after getting it secondhand. If you had any luck...lemme know please!
|That is a nice piece of equipment to have. you can get the manual from the FTP site;
|Do what I did one time. I took an undefinable cap to Radio Shack and used one of their Capacitor Meters to get the value.
|best place to buy IC's
|Your question reminds me of my neighbor who told me his radio kept popping fuses all the time. He replaced the 2 amp fuse with a 15 amp fuse so it wouldn't blow again. He was right. The fuse did not blow again. The radio went up in smoke instead. You
|Remove the back from the TV and with an air compressor, blow out all the dust that may have accumulated in the set. Dust bunnies can cause an occasional spark or two. Next, with the back off, turn ON your TV in the dark and look in the back and see if y
|Re: Panasonic TX21S3TC colour TV
|Have you find please the problem for your tv? It would help me in a similar situATION.
[quote:8ab949099e="pajs64"]I been having this problem with my TV, When i try to switch it on it goes straight to standby, the strange thing is that the le