| Date | Header | Text |
|---|
| 14-09-2007 | transformer thermal fuse | i have a small battery charger to keep my classic car battery topped up,
after about 2 years of continued use it gave up, after stripping it i found the thermal fuse in the input of the transformer blown,, i replaced the fuse with the same rating but the |
| 14-09-2007 | | Hi,
I have h/k AVR240 .Could you send me a schematic for this HARMAN KARDON?
My email: [email protected]
Thanks a lot :D |
| 14-09-2007 | | I've got the User's Guide, but it isn't free.
http://www.justmanuals.com/product_info.php?products_id=15364
$11.77 and instant download.
[email protected] |
| 14-09-2007 | | In general, replacing the fuse SHOULD take care of the problem, but it is possible that one or some of the windings on the transformer itself has been damaged,causing it to overheat --OR some sort of electronic problem putting too much load on the txform |
| 14-09-2007 | Toshiba TP50f50 | i aquired a toshiba model tp50f50 and was attempting to optimize some of the service settings. i was adjusting HIT and while scrolling through the vol down key my finger sliped and hit the 0 key. the tv screen went black and i can not get it back. there i |
| 14-09-2007 | | the primary 240vac side is only a lead and a plug ( which tests ok ),, connected via the thermal fuse,, secondary side is 16.5v 1amp ,, the resistance of the primary side is 214ohms,, does this look like a shorted primary,, would a fault in the seconda |
| 14-09-2007 | face | sometimes the solder connections break loose on these faces. the knobs on the volume control and joystick should come off. they are on a bit tight sometimes so you may have to pry on them gently. |
| 14-09-2007 | | Could not say for sure if the primary reading is correct or not without knowing or comparing it with another one---Your reading does not sound off though?----may also be an intermittent problem where the coil's isolation may be braking down under load?
|
| 14-09-2007 | | Remove the pip board and jump pins w/board flipped up 5 to 11 closest to you then 7 to 9. |
| 14-09-2007 | Blaupunkt CD Changer Beeps | Hello. Noob here. I just bought a 1999 Opel Vectra with a fitted Blaupunkt 6 CD changer. However when I load a cd and hit play it beeps loudly with the words 'CD SAFE' coming up on the dash display, while the music plays also. The instruction manual was n |
| 14-09-2007 | | Why not buy a after market oil gauge? |
| 14-09-2007 | | http://www.original-remote-control.co.uk/control/remote/Matsui2107RRemote_3222472.htm |
| 14-09-2007 | Switching from European plug to american standard | Hi everyone! I have just returned form Germany after 4 years in the airforce. I have a samsung TV that has a standard european round two prong plug. Of course it didn't dawn on me that it had that plug until I got back to the states. So I need to switch i |
| 15-09-2007 | | You should check with Samsung about that. European voltages are different than they are here. What does it say on the back of the TV on the rating plate?
[email protected] |
| 15-09-2007 | radio code | radio code for grundig s/n:722039a0024390 |
| 15-09-2007 | Code for BETA4 S/N:VW2Z2S4156038 | Helo, I need a code for a BETA4 1HO 035 152 Grundig carradio.
The serial number of the radio is VW2Z2S4156038. |
| 15-09-2007 | hello | I need service manual & schematic for beomaster 2000 (bang & olufsen) chasis 2801
thanks. |
| 15-09-2007 | service manual nokia/itt CT3711 | Hello everyboby!
This is my first question to this forum, but I use it several times.
I looking for a schematic of a nokia CT3711. This TV doesn't go in standby mode: when I turn off it, the vertical stage stops but the HV and the tube remain on!
|
| 15-09-2007 | faulty fujitsu monitor | I have exactly the same monitor and exactly the same problem. It seems to be an issue with the connectors in the cable, because sometimes when you wiggle the cable around at the back of the PC, the picture stays on a bit longer. However, as the cable goes |
| 15-09-2007 | Samsung 17" monitor strange problem..plz help | My samsung 753s monitor's led won't light up at all.On disconnecting the vga cable there's no self test as well..appears dead.But when connected to the pc and after 5mins or so,when the monitor's on-off switch is toggled a couple of times it comes on and |
| 15-09-2007 | Schematic/ Service Manual | Mark,
I am looking for the schematic/ service manuals for a Sony KV-32S26, Sony KV-32S40 and a Funai/Sylvania 6432TFY. Could you help with any of those? Please e-mail me at [email protected].
Thanks,
Jim |