|03-09-2010||Well, this is what I searched for, and the result that was given.
Check chassis number on your set. May still be "close enough" for area you need.|
I tried with one audio amplifier but it distorts the square wave signals especially at very low frequency of 1 or 2 Hz.
-the required output current of 25 Amp, 800Watt
-the load impedance 1-2 ohms
|03-09-2010||Teac MV-525 - Burnt resistor||I am working with a Teac MV-525 VCR
that has a burnt resistor that I cannot identify, R7002
on the main board.
Need the value of the resistor or the service manual.
It was made by Funai.
|03-09-2010||Service Manual: [url]http://www.servicemanuals.net/ServiceManual/TEAC/mv+525/pos1/results.aspx[/url]|
|03-09-2010||Q502 is known to go bad it's a 2sk3326.|
|03-09-2010||Do you have a part number?|
|04-09-2010||SM parts list states:
T702 BW0O631 HFL1735YP-RC ASS'Y ?|
I seen they had the manual earlier today.
I would like to see if someone can tell me what
the value of the resistor is. Given the age of the unit
it wouldn't be too smart to drop 20 bucks into a manual.|
|04-09-2010||spare part||hi minnie, part no. can't see on the ht tran, but according to the prt list in service manual it is the same as jtss1957 mentioned. BWO0631 HF1735YP-RC. No way to check ht tran?
thanks both of you|
|04-09-2010||Totally charred? If you could make out the 1st band, that would narrow it down a little - if you could make out the 1st and 2nd bands that would narrow it down a lot. 8)|
|04-09-2010||These are what I use to test flybacks:
|04-09-2010||Andrew- You're right, I remember seeing this manual but it's on my HD. I haven't put it up on my sites yet. Sorry about that.
|04-09-2010||[quote:4d73da81db="jts1957"]These are what I use to test flybacks:
Cheaper to buy a new TV then a Sencore!|
|04-09-2010||Paid them off more than a decade ago, still working great, still earning their keep. Their scope and variac are the ones that get the most use these days though.|