Date | Header | Text |
12-05-2008 | | I think you should first check for bad electrolytic caps in the power supply. Usually, but not always, the bad ones can be identified by a bulging top and possibly leakage. Small capacitors (6-7 mm diameter and smaller) that have been subjected to heat fr |
12-05-2008 | Bush DRVH02 video combi | I need a manual for the above machine, Could any one advise where I can get one from please? Bush say my nmachine is not listed. It maust be as i am looking at it!! |
12-05-2008 | Grundig cuc6360 stuck in standby | grundig cuc 6360 model ST 70-755/9 TOP
stuck on stand by +H voltage is 1.3v
TDA8173 OK ANY IDEAS |
12-05-2008 | | Check all of your connectors. Sounds like one may be loose or they sent you a bad board. Toshiba's notorious for new and defective boards. |
12-05-2008 | | I checked them when i installed it. At first i didnt have one of the ribbons that go to the screen seated properly, so i fixed it and check all connectors again. How do i test the board? Thats where i need to start. Im sure there is a couple of pins i can |
12-05-2008 | help how to test siemens vdo cd/radio | the model of radio is PSARCD100-04. this is my own radio removed from peugeot 307 2004. the car sustained flood damage just up to the radio level. after removing radio and lid,i found the water had just touched the rear near the plug loom.i cant really te |
12-05-2008 | | Put the original board back in and Short pins 1 and 2 on the logic board. It will display an internal pattern as long as the pins are shorted. |
13-05-2008 | | Your best bet would probably be thru their support line.
In doing a little search, looks like you may want to look at that model number again as it is supposed to be [b:f0441fda27] [u:f0441fda27]DVRHS02[/u:f0441fda27][/b:f0441fda27] |
13-05-2008 | | you should check High tension. i think capacitor in High tension was fail. :( [img][/img] |
13-05-2008 | Need Urgently Kenwood PW18-2ATP Service Manual | Hi,
My Kenwood PW18-2ATP Power Supply was down recently with no
display. Suspect the internal circuitry is giving the problem and I
needed the Service Manual urgently.
Please help!!!
Cheers!
milkyway13 |
13-05-2008 | Xerox 6110 partlist | Good morning,
have someone parts list of Xerox Phaser 6110 MFP?
I need to change sensor arm in fuser unit or if isn't, the fuser unit.
Could someone link code for this part or the link to download the parts list?
Thanks you. |
13-05-2008 | 12V charger | Usually the charger has a 240/12 volts transformer inside.
The transformer produces Alternating Current which needs to be rectified first, to Direct Current with some ripple on it, to make it usefull as a charger.
At the Low Voltage side of the TX |
13-05-2008 | 6000cd manual | Please, anyone can help me with the operating manual for 6000cd audio system from the new ford focus 2008 |