Date | Header | Text |
16-10-2009 | Samsung HLN467WX/XAA FREE Service Manual request | I'm a poor man with a rich mans TV. I would really appreciate a FREE service manual for my Samsung HLN467WX/XAA TV. I'm mechanically and electronically inclined, so hopefully this will help me troubleshoot my TV's power up and immediate shutdown issue. It |
16-10-2009 | vw mcd blaupunkt 7612 001 507 bn0 881 dont work | hello,
i have here one mcd blaupunkt bno 881. radio dont work. i check clock,data on processor but only on sda 5v on scl 0,3v.
can anybody help with this? i have no datasheet....
thanx |
16-10-2009 | | Never mind...
I trashed the TV. F- it. |
16-10-2009 | where to find chip | Thanks. vtech |
16-10-2009 | | It's not free but if you eventually decide you are willing to spend about $12 US for the complete service manual with schematics, then you can get it at www.schematics.me (it's not listed yet but it IS available so use the Request/Contact form to request |
16-10-2009 | sansui 3900z | Hi Boggs,
Thanks for the tip.
Would you also happen to have any clues for me to repair a R-channel.
I've transplanted most transistors from left to right hoping that I would move the problem to the left channel.
Left channel still fine, right chann |
16-10-2009 | Re: I need schematic diagram SANSUI model 3900Z/4900Z/5900Z | [quote:037186eb32="gjem"]hello
please I need schematic diagram SANSUI model 3900Z/4900Z/5900Z
thanks[/quote:037186eb32]
hi,
did you manage to fix your sansui 3900z?
please let me know
regards |
16-10-2009 | Sony KDL46s4100 schematics | hey can any please provide me with a sony KDL46s4100 LCD schematic
thanks in advance |
16-10-2009 | | This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after payment from http://www.justmanuals.com
[email protected] |
17-10-2009 | daenyx code for univ remote | I found it!
0872 |
17-10-2009 | remote | Staying at hotel with a BR100Z and Front Desk had no clue how to fix. Your instructions worked great. Thanks. :D |
17-10-2009 | | Strictly depends on your application and type of motor; In general, the "grinding" noise is normally caused by dried lubricant or worn out bearings &/or bushings supporting the spinning armature on either end of the housing.
If it is a seal |
17-10-2009 | | The motor does open...quite easily, in fact. I can pop it open by twisting a screwdriver in one of the slots on the edge. Inside the two halves is a spinning cylindrical magnet with a spindle that serves as the drive shaft. The bottom of the shaft sits |
17-10-2009 | denon ud-m3 cd tray failure | some one please help..... ...please provide steps for repair. I see that many have had this exact same problem....I cannot find the steps
thanks |