Date | Header | Text |
17-01-2009 | TV has Wavy Picture til Warmed Up | I have a big screen Toshiba 50H12 projection TV. It is about 5 years old. Recently, the picture has become wavy and distorted when we first turn on the TV. After about 10 minutes of being on, the picture becomes clear again. Does anyone know what the |
17-01-2009 | Re: switch | You need to get inside and clean the p.c. board and wiper of the volume switch. Q-Tip dipped in isop. alcohol. |
17-01-2009 | Re: Wavy | If On Screen display is NOT affected, is Bad Hyper board. |
17-01-2009 | | Thank you for the advice but that isn't it. I've allredy cleaned the inside of the volume button by takeing it apart. As for the motherboard i've also cleaned it with alcohol. everything was cleaned with alcohol. something else please. what can it be from |
18-01-2009 | 57f500 fbt | i need a flyback for a 57f500 but everyone is telling they are obselete i have search high and low for a bw03003, bw03001, and a bw02891 which i am told will fit. does anyone have any laying around |
18-01-2009 | Re: Flyback transformer | I'm presuming it's for a Hitachi.
BW02891 is still "listed." And it's NOT listed in their "this part is no longer available" area (although BOTH of the other numbers you mention are).
http://www.partstore.com/Part/Hitachi+Ltd/Hit |
18-01-2009 | Help need to repair my VCR Panasonic NV_G10 | My old VCR Panasonic NV_G10 need repair, all is working fine except the play function. Drum doesn't spin up, just a little movement and then all stop. Replaced AN6387 (Cylinder Motor Servo) but no luck. Thanks' for any advice.
Service manual:
http://w |
18-01-2009 | Picture size = Convergence? Hitach C57-WD8000 | Hey all!
Quite some time ago, the fly back on my Hitachi went out. I got it repaired by a Hitachi service repair man. He got it working again and then went through and set the convergence on the TV and we thought all was well.
Well, after some time |
18-01-2009 | | [i:74a0f4b322]"I should remaind that it's a full circle rotating button. Once again i've opened the face and cleand the insides of the volume button. Pluged again, the same problem, going crazy... "[/i:74a0f4b322]
If 5v good, check GND connecti |
18-01-2009 | | If the drum is not physically binding and free to turn and you have the drive and supply voltages present and not buckling under load, it is likely the drum motor itself( although rare, failure of the hall sensor inside the motor can prevent operation). |
18-01-2009 | [OLD owner manual OR datasheet manual ] Thanks :) | hello all
first in advance thanks if you can help me :)
well i need the owner manual and/or the datasheet manual for an old turntable
manufacturer : Pioneer
model : PL-510A
spec : direct drive audio turntable
again thanks |
18-01-2009 | Service manual DCR-PC330E | Service manual needed
Thanks a lot. |