Date | Header | Text |
15-10-2009 | HOW TO FIX C31 ERROR CODES AND CASSETTE DOOR NOT OPENING. | HI, DONT HIT YOUR CAMERA! I KNOW WHAT CAUSES THIS PROBLEM AND ITS EASY TO SORT OUT.
THE C31 ERROR CODES AND ALSO CASSETTE DOOR NOT OPENING PROPERLY IS USUALLY CAUSED BY A VERY FINE RESIDUE BUILDUP ON THE BATTERY TERMINALS AND THE ONES ON THE CAMERA AND A |
15-10-2009 | The problem root cause. | Replace 2 capacitors on the board right in the middle of the back of the screen, has 8 screws and 7 connectors. They are side by side. Both are the same value. 3,300 uf (microfarad), 10 volt. They are EASY to see.
The tops of the bad capacitors are bu |
15-10-2009 | | KA3883 is actually obsolete and can only be ordered in mass quantities for manufacturing purposes.
However, you can use a UC3843 as a substitute, available in single quantities from various vendors..[url=http://search.digikey.com/scripts/DkSearch/dksus.d |
15-10-2009 | Remote acess to other PC by network | Hi guy
Good evening,
Someone know some way to acess other computer by network invisible!! If exist any program or way, please if someone could give some explanation I will apreciate very much.
Thanks.
Adrian |
15-10-2009 | A bit confused | When I debated with the TV guy about burn in (I thought he was going to blame me for the damage) I asked him if it was really burn in, then why do I have a uniform one inch vertical white bar on the left side of the screen? :roll: and a vertical inconsist |
15-10-2009 | | Well I found it. A cold solder on the front board. Not exactly sure where on the board but resoldered the whole thing and all is good. Probably on the display those get some heat. That is always my last ditch effort and 98% of the time works.
PS I did |
15-10-2009 | | [quote:7b09ced814="minnie"]Sounds like a firmware issue locking up the tuner. Call Sony and ask them if they have a firmware update.[/quote:7b09ced814]
Well, it's an old model... CRT TV set from 1997. Bought in 1998.
Thank you for the suggestion, but I |
15-10-2009 | | Nobody, even a word or two :?: :?: :?: |
16-10-2009 | | [quote:bb3c151812="minnie"]The color wheel has to spin before the dmd sends out the lamp enable pulse. You could have a bad color wheel. PM me the version under the serial number or the serial number.[/quote:bb3c151812]
Pm sent. Thanks for the help min |
16-10-2009 | AC synchronous motors | Many stereo turntables - record players - are driven by a small AC synchronous motor. It's a magnet on a spindle, rotating inside a two-piece shell. So my question is simple - Is such a motor supposed to have oil in it? |
16-10-2009 | Vizio L32 Powers Up but No Audio or Video | I have a Vizio L32 hdtv10a that my daughter had. The picture went out and there is no sound, but the power light turns green when it is turned on, and goes back to yellow when the power button is turned off. She says Vizio told her it was probably the b |
16-10-2009 | | There is no need or requirement to have oil inside an electric motor.
If you see any signs, it is from the end bearings that support the shaft. |
16-10-2009 | | Bad solder joint (same as cold solder) is the same as a broken/intermittent connection between two points. If there is high current involved, it will cause it to heat up and creates a voltage drop.
Depending on the severity of the junction, it will begin |
16-10-2009 | | I don't have an index out side of US models. |
16-10-2009 | | Easy, PM me! 240hz is a knock off of 60hz refresh rate. |
16-10-2009 | | This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after payment from http://www.justmanuals.com
[email protected] |
16-10-2009 | | Thanks very much for the reply. Could you tell me why the motor would develop a grinding noise that starts after around two hours of use? If so...what could be done to repair that? |
16-10-2009 | | Thx for your help Paul!
I dont think I can spend so much money on such a little failure, now I´m looking for a second-hand monitor, same model...
greetings from Germany! |
16-10-2009 | Fiat idea radio probs | The radio on my Fiat Idea has started switching itself on when either the ignition is on or not, thus running down the battery. I changed the battery, not knowing about the radio, and tho it appears to work OK, its started switching on when turned off. A |
16-10-2009 | service manual request | if anybody have HITACHI SR-504 service manual please upload.
Meledath[/quote] |
16-10-2009 | hitachi SR-504 service manual | anybody having this manual please upload[size=18:5934f73b2c][/size:5934f73b2c][color=blue:5934f73b2c][/color:5934f73b2c] |