|02-05-2009||dataheet of stv2100||is there any further information about stv2100.i need information about its pins; like a diagram in which stv2100 is used.thanks vtech forr help.|
|02-05-2009||[quote:2d5daa5f64]Pincushion distortion is a common type of distortion in CRT monitors in which horizontal and vertical lines bend inwards toward the center of the display. The distortion is most noticeable at the edges of the display. Pincushion distorti|
|02-05-2009||Re: Memorex MT1701||[quote:c477ade957="rsfusion77"]I have an MT1701, which goes black after a couple of secs. I've replaced the backlight inverter with same results. I read somewhere in a forum, that this can happen with old/defective lamps. My question is, if a lamp were de|
|02-05-2009||2 years. Better late than never.|
|02-05-2009||GRUNDIG T55-1010 says protected--PLEASE HELP!!!!!||Due to our electric shooting on and off our tv now just has a blue screen and flashes PROTECTED.
We don't have a code, but how on earth do I fix this???!
Any help will be EXTREMELY appreciated!
|02-05-2009||E w problem||thanks ,so i have to check every componet there it may be capacitor resistor etc....is there any special component which is responsible for this problem.any why i try to replace any componet i doubt.thanks again for explanation. :)|
|03-05-2009||Do these pics look like convergence IC issue?
|03-05-2009||Don't remember what set actually used it but you can see the pins on their respective datsheets posted above.|
|03-05-2009||What specifically in the hyper module? I just replaced the 10uF caps. Maybe I should go for the 100uf caps next? Any ideas?|
|03-05-2009||Recheck your work. Easy to break/lift a trace.
:?: I feel the timing is just too close between the failures.|
|03-05-2009||I agree. That was my first thought. The funny thing is after the first repair the picture looked great for one day. Then I turned the set on the next day and got that. I will recheck the work. Thanks.|
|03-05-2009||Definitely a belt issue as they had all deteriorated into so much goo--nearly impossible to remove. Bought the service manual and it tells me everything but how to replace the belts! :shock:|
|03-05-2009||Scrape away the majority of "goo" with a small pocket screwdriver. A Q-tip dipped in rubbing alcohol will remove remainder (allow to evaporate - don't allow on good belts).
Once you've completed that, you should have a fairly good idea of how t|
|03-05-2009||I've done the cleaning--at least as good as it will likely get. As for the routing of the belts I really can't tell and I'm a bit stumped as to how to get the counter belt on. I have an exploded view of the transport mechanism but it really doesn't tell m|
|03-05-2009||They are changing to digital in the uk, but not in my area until 2011.So I have a bit to wait :)|
|03-05-2009||Recherche Datasheet BA631B||Bonjour a tous
J'ai un probleme sur une alimentation de disque dur externe ( My Book de western Digital)
Apparemment le circuit BA631B est en cour-circuit.
Je n'arrive pas a trouver ce qu'est ce circuit, pouvez vous me donner des informations (voir pho|
|03-05-2009||need the same||I need the same drives does anyone have them? email me at [email protected] thanks!!|